How it Works
Moneual
Loading...
RYDISR750
User Manual
47 pgs5.16 Mb0

Moneual RYDISR750 User Manual

User Manual
RYDIS R750
Copyright ⓒ 2010 MONEUAL Inc. All rights reserved. The MONEUAL, MONCASO, MiNEW, RYDIS, SONAMU are trademarks, or registered trademarks of MONEUAL Inc. in the Republic of Korea and/or other counties.
RYDIS R750
User Manual
Table of Contents
KOREAN
Cautions for Safety 5 Parts 9 Before using the product 10 Name of parts 11 Robot cleaner 11 Indicator 12 Charger 13 Installing Product 14 Basic cleaning (automatic cleaning) 17 Using advanced cleaning functions 18 Focused cleaning 18 Cleaning corners 18 Cleaning under the bed 19 Selecting a room for cleaning 19 Cleaning through manual control 20 Cleaning through manual control 2- control of the motion 20 Setup of time and reservation 23 Setting current time 23 Setting reservation 24 Setup and execution of macros 25 Setting macros 25 Executing macros 26 Using the indicator 27 Using the product for the room assortment mode 27 Using through setup of cleaning areas 28 Descriptions for remote controller buttons 30 Managing the product 32 Cleaning the dust box 32 Replacing the filter 33 Cleaning the falling point-detecting sensor 34 Cleaning wheels 34 Cleaning the dust intake 35 Battery usage and management 37 Voice announcement list 40 System error codes list 41 Checkpoints before request for after-sales service 42 Specifications 43
4 RYDIS R750
Cautions for Safety
The instructions with the following caution marks must be carefully read and fol­lowed in order to use the product properly and to prevent accident or damage which may occur during the operation of the product.
Meanings of caution icons
KOREAN
Important
It refers to important information, definitions, general knowledge and references.
If you do not follow the instruction with this warning icon, a
Warning
serious injury or property loss may occur.
If you do not follow the instruction with this danger icon, a
Danger
serious injury, death, or property loss may occur.
Warning
Before using the product
Remove light clothes or fragile materials from the floor.
These matters may obstruct movement of the product or cause a breakdown of the product.
Remove any obstacle from the floor in the space where the product travels about.
The product can’t travel the area which is blocked with an obstacle of certain height.
Do not install the product in the place under direct sunlight.
Direct sunlight may cause discoloration of the product. Adapters may cause electric shock or fire due to overheat during charging.
Do not install the charger on an inclined floor, and do not give an impact to the charger.
The charger may be damaged or broken.
Install the charger in a place that can be easily detected by the robot.
If the site is in a corner or has many obstacles around it, automatic charging is not possible.
Do not use the product in the room with a child or an elderly person who is left alone.
A child or an elderly person can be frightened or injured.
Make sure that the power of the charger is always supplied.
Otherwise, you cannot use the function of making the robot go back to the charger for automatic charging after it finishes cleaning.
RYDIS R750
5
In using the product
KOREAN
Do not stand or sit on the product.
Movement of the product may cause an injury or the product can be damaged.
Do not use the product in a narrow and elevated place such as a desk.
The product may fell down, causing an injury to people or damage to the product.
Make sure that no liquid enters the product.
The product may malfunction or can be damaged.
If the product happens to inhale plastic bags or others, they should be immediately removed.
If the dust intake gets clogged and the product is used for a long time with the internal motor over-
heated, the product will be damaged.
Do not use the enclosed battery charger for charging of any other product.
The charger or other products can be damaged.
Make sure that clothes, hair, fingers or other body parts are not caught by the wheels.
An injury may occur.
Do not press the bumper of the product severely or give excessive shock.
The bumper sensor can be damaged and then work abnormally.
Do not keep or use the product at too low or high temperature.
Do not use the product at the temperature of - 5℃ or lower or 35℃ or higher.
Do not make the robot perform cleaning with the dust box filled with dust.
It can cause reduction in sucking power.
Check if the filer is inserted into the dust box.
If the robot gets activated with no filter, it can cause product failure.
Prevent the main brush and the side brush from being clogged with hairs or other foreign
substances.
It can cause noise and reduction in sucking power or damage to the product.
Before using the product, clear away stuffs from the floor and make arrangement nearby.
Small dish towels, bath towels, pads, telephone lines, power cables, strings or belts can be en-
tangled with the operating wheels or the brushes.
Make sure to remove stuffs that can be broken (ceramic wares, glass cups, etc.).
Do not use the product in a site whose walls or floor is made of mirror or glass.
The obstacle sensor of the robot cleaner uses an infrared sensor and so it may not see glass or
mirrors as obstacle.
Do not use the product in a utility room, on a wet floor, in stairs, on a table or shelf, in an un-
derground room, a warehouse, a commercial building or the outdoors.
If you have dropped the product or caused an impact to the product, contact the designated
service center immediately.
6 RYDIS R750
Electrical cautions
Make sure to use the specified voltage and current.
Power supply outside the specifications ranges may cause a serious damage to the product.
The battery can be discharged if the product is not used for a long time.
If the battery is fully discharged, charge it manually.
Do not use a damaged power cord or plug.
You can get shocked or seriously injured.
If the power cord of the charger is damaged, contact the service center immediately.
Make sure that the power cord is not pulled or pressed down by the door.
The power cord can be pulled out or damaged.
When connecting / disconnecting the plug into / from the receptacle, make sure to hold the
plug part tight, rather than to pull the cord.
Do not touch the power cord with wet hands.
You can get shocked.
If the product is wet, pull out the power cord, and dry up the product before use.
An electric shock or a fire may occur. If water enters the product, contact the service center.
Use the enclosed charger only.
The product may be damaged due to overvoltage, or a fire or electric shock may occur.
Do not bend the power cord with excessive force or place a heavy stuff on it.
A damaged cord may cause an electric shock or a fire.
Do not install the charger in a place which is damp or dusty, where water splashes or where
steam belches out.
The product may malfunction, or a shock or damage of the product may occur.
Do not contact any metal objects such as clip and pin to the charger terminal.
It can cause electric shock and fire.
For indicator power, use rated batteries and adapters.
If not, the product can be damaged and then set afire or it may not work.
In case of insufficient indicator battery, replace with a new one.
Or, indicator functions may not work normally.
KOREAN
RYDIS R750
7
In product management
KOREAN
Use the standard filter only.
No warranty service will apply to any error or failure of the product caused due to a substandard filter.
In cleaning the product, turn the power off in advance.
If you happen to care for the product while it is working or the power is being connected, you can get hurt.
Periodically clear brushes, dust box, dust box filter and dust intake.
If the product is used for a long time with no clearing done, it can work abnormally and cause product failure.
Others
Do not operate the product in a site with inflammable substances.
Places with alcohol, gasoline, distilled water, thinners, ashtrays with flames, candle lights and stoves in them
Disassembling or repairing the product must be performed by the designated service center or the authorized engineers.
The product can be damaged or users can get shocked.
Do not discard the battery carelessly.
If you put it near fire or expose it to the sun’s rays for a long time, it can cause fire and explosion. Discard used-up batteries safely according to local discarding regulations.
Danger
Do not place hot or flammable objects such as cigarette, candle, heater, match or gasoline.
The product can be badly damaged or a fire may break out.
Do not use the product near an explosive object or in an explosive place.
8 RYDIS R750
Parts
Main body Battery (Inserted into the main body) Charger Charger adapter Charger adapter power cord Indicator Indicator adapter (Optional/Not provided with the product) Remote control Battery for remote control (2 X AAA) 2 X Side brush Dustcloth guard 2 X Dustcloth Brush Dust box filter User manual
KOREAN
The appearance and specifications are subject to change without prior notice for better product functions or performance.
The battery, the filter, tools and dustcloths are consumables. You need separate purchase for used-up or damaged consumables to replace them. The life span of the dust box filter is around six months and it can increase/decrease depending on usage environments.
Make sure to use expendables in standard. For inquires for appropriate standards, please contact our customer care center.
RYDIS R750
9
Before using the product
KOREAN
※ The appearance, specifications and other parts of the product are subject to change
without prior notice for better features.
Install the left/right side brushes in the robot cleaner.
01.
Turn over the robot cleaner and press the left/right side brushes to insert them. Make sure to check the groove(D) of the side brushes before inserting them.
Make sure to prevent the product and the components from being shocked in opening the
02.
package.
For product installation, see the page 14.
When you open the product package, charge it manually before others.
03.
In initial opening, the battery may have been discharged and not work. For manual charging method, see the page 15.
Clear away stuffs from the floor to be cleaned.
04.
Clear away objects, which might be broken or fall, from the floor. For carpets and other decorative stuffs with long tassels, they can hinder the product from moving normally. Fold the tassels or clear away the carpets.
If the dust box of the robot cleaner gets filled, the cleaning performance will be worsened.
05.
After cleaning operation, check if the dust box is filled up.
For clearing methods, see the page 33.
If there are foreign substances in the location-detecting sensor and the wheels, remove them.
06.
Or, the robot cleaner may not move in an accurate way.
For each location, see the page 34-36.
Children or the old and the weak may get frightened at the robot.
07.
To prevent children or the old and the weak nearby from being taken aback, let them fully understand the product is being working.
Be careful that the robot cleaner can fall from some sites.
08.
At an entrance and a place whose height is different from that of the living room, if shoes are placed at entrance, the robot might see the shoes as floor, falling from the living room. Use the product carefully in a narrow site (e.g. desks, tables, etc.) where the robot may fall.
10 RYDIS R750
Name of parts
Robot cleaner(Top)
Control buttons and operation lamps
KOREAN
① Obstacle- and signal-detecting sensor ② Bumper ③ Control buttons and operation lamps
① Start/Stop button ② Mode setup button ③ Power button ④ Brightness-detecting sensor ⑤ Sucking power lamp ⑥ Battery status lamp ⑦ Reservation information lamp ⑧ Room selection lamp ⑨ Time lamp ⑩ Operation mode lamp
Robot cleaner(Rear)
① Dust box ② Air outlet ③ Power switch ④ Adapter jack
RYDIS R750
11
Robot cleaner(Bottom)
KOREAN
Indicator(Top)
① Falling point-detecting sensor ② Wheels ③ Charging terminal ④ Side brush mounting pin ⑤ Dust intake ⑥ Dustcloth guard mounting holes
① Signal transmission sensor ② Mode switch button ③ Distance setup button ④ Indicator number setup button
Indicator(Bottom)
12 RYDIS R750
① Battery cover
Charger(Front)
Charger(Rear)
KOREAN
① Operation lamp ② Guide signal transmission sensor ③ Charging terminal
① Adapter jack ② Adapter compartment
RYDIS R750
13
Installing Product
KOREAN
01. Plug the adapter power cord in the adapter and connect with the power.
02. Connect the charger adapter with the charger.
Once the power is connected, the blue lamp is turned on at the front. For appropriate charging of the product, the charger adapter should be connected with the power in any case.
03. Arrange the position of the charger.
The charger should be distant at least 1m away from the front and side parts. The wall facing the rear of the charger should not be made of glass or glossy materials. Insert the adapter into the compartment of the charger, properly. If you put it in a site under direct sunlight, automatic charging may not be made or the product can be discolored/ decolorized.
14 RYDIS R750
04. Install the dustcloth guard into the robot cleaner.
If you do not want the dustcloth function, go to the next procedure.
05. Turn on the power switch of the robot cleaner (at the left of the rear dust box).
When you lift it to the [ ● ] position, the product gets turned on.
Without the power switch turned on, no charging will be made.
KOREAN
06. Put the robot cleaner in the charger with your both hands and activate manual
Locate the robot cleaner and the charging terminal of the charger, face to face. The charging time can be around one (1) hour depending on the remaining battery capacity. After 1-hour charging, you can use the product for around one (1) hour. Usage time may vary depending on the strength of the sucking power.
Battery lamp
Being charged
Charging completed
Low battery
RYDIS R750
Blinks 1 time/sec
Stops blinking
Blinks 4 times/sec
15
07. Insert the battery of the remote controller and the indicator.
KOREAN
You need to insert the battery in a correct position following the polarity data indicated in the insertion position.
08. Install the indicator in a desired position.
The product can perform cleaning, anyway, with no indicator installed. For detailed installation methods, see the page 27.
16 RYDIS R750
Loading...
+ 32 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use