Monarch Instrument Track-It™Pressure Calibration Software
Install
Track-It™ Pressure Calibration Software
ug
Track-It™ Pressure Calibration Software is a software Wizard,
it automatically prompts you through the step
to perform
your calibration
Once the connection has been established, it will be confirmed by a green
“LOGGER CONNECTED”
. This window allows you to view real
ti
The software detects the full scale value and asks for a pressure source to
be applied at that approximate value.
Wait for your source to stabilize, enter the reference value, and press OK.
Some loggers support two point calibrations, and some support three
points. The software automatically detects which is appropriate and
prompts the
adjustment is allow
The final calibration point is the low value of the range. Wait for a stable
low value and press “Send Calibration”. This completes the procedure.
12/2017
g
g
Track-It™ Pressure Calibration Software works with all Monarch
Instrument Pressure Series Data Loggers, Digital Gauges, and Transmitters.
IMPORTANT! Do not connect the logger prior to installing the software.
SERIAL COMMUNICATION: The logger has a mini USB port. Aft e r t h e so f t w a r e a n d US B d r i v e r s h av e b e e n i n s t al l e d p l
the cable into this port and the other end into the USB port on your PC/Laptop. The softwareneeds to be installed in
order to work with the logger.
-by-step pr ocedure
.
indication
me pressure values from the DUT. To continue, click Next>.
next appropriate step. In a three point calibration, an
ed for approximately mid-range.
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
Loading...