Monarch 5396-0513-CAL, 5396-0522-CAL, 5396-0524-CAL, 5396-0103-CAL, 5396-0525-CAL User manual

Install USB driver and Track-ItTM Software

1

IMPORTANT! Do NOT plug the Track-It Data Logger into the USB port
until AFTER the USB Drivers and Track-It Software have been
installed.

Download Track-It Data Logger Software from:

http://www.monarchinstrument.com/Software/Track-It_Software.zip

Unzip the downloaded file to a local directory on your PC.

Double click “CD_Start.exe”. This will launch the Track-It Data Loggers
Splash screen shown to the right.

1. Click “Install the USB
Driver” and follow the
prompts. Click “Continue
Anyway” if you see the a
message about software
installation.

2. Click “Install Software”
and follow the instructions
to complete the installation.
The Software is now
installed and ready to use.

3. Logger and Software
manuals may also be
accessed here

Install data logger battery (if required)

2

Install the battery that was supplied with your Track-It

TM

data logger. Refer

to the diagrams below for installation. Certain models will have battery

pre-installed.

Remove threaded end

cap with coin and

insert battery as

shown

Rugged Temp

3.6V 1/2AA Lithium
High Tempture

Connect data logger and Start Track-ItTM Software

3

Remove thread-

ed cap and

insert battery as

shown

Pressure/

Temp

3.6V 1/2AA

Remove threaded bezel ring

and circular cover on back of

logger. Insert battery as shown

Pressure/Temp with Display

3.6V 1/2AA

Batteries in

“Thumb Drive”

type loggers are

pre-installed

Temp,

RHTemp, DC I/

V, AC Event,

Baro/Temp

3V CR2032 coin

cell or 3.6V

EF651625
(LTC-7PN)

Plug the Track-It logger into an available USB port on the PC. Some
models plug directly into the USB port others connect to the USB port with
a cable (which is supplied). If the Found New Hardware Wizard appears,
follow the prompts to complete the installation.

Start the Track-It Software by double clicking the Track-It icon
(shown at right) on your PC or from the Start menu.

Find Quality Products Online at: [e-mail]

www.GlobalTestSupply.com

Connect to your data logger

4

If the USB drivers installed properly you will see “Device Connected”
displayed in the lower right hand corner of the Track-It™ Software
window.

You can now begin using Track-It™ Software to configure your data
logger and/or view recorded data.

Track-It™ Software will list all Track-It™ Data Loggers connected to your
PC. To view the list and switch between loggers click on Devices then
Device List.

Configure and start logging data

5

Select the “Device Setup” tab as shown. The software will
automatically retrieve and display the data logger configuration.

Review default factory configuration settings and make any
necessary changes - sample rates, triggers, alarms etc. Be sure that the
time and date is set properly.
Click the “Send Config” button under the Device Configuration section

of the window. Your data logger is now operational!

Para la traducción española, ver CD

QUICK START GUIDE

Find Quality Products Online at: [e-mail]

www.GlobalTestSupply.com

Für die deutsche Übersetzung, siehe CD
Pour la traduction française, voir le CD
Per la tr

aduzione italiana, vedi CD