Monarch 433TSPW2K, 295SEPC2K, 318LIPW2K Quick Manual

1A -General information
The Transmitter Solutions Monarch - 433TSPW2K is a key chain style mini transmitteroperating at 433.92MHz. It has been designedfor use with programmable telephone entry, security, and access control systems operatingwith a MHz frequencyreceiver.
codes .
433.92 The code sent by the transmitter includes a 16 bit security code which allows up to 65,536 number combinations and 8 bits of facility code which allowsup to256 facility
CONTENTS
1A -General information 1B -Technical specifications 1C -Main components
1 - TRANSMITTER OVERVIEW
2 - NUMBERING
3 - PROGRAMMING
4 - OPERATION
5 - BATTERY ACCESS
1B - Technical specifications
Operating frequency 433.92 MHz
Number of keys: 2
Battery life: 18 24 months
Number combinations :
Operating temperature: -20°F÷+131°F (-20°C
Overall dimensions: 2.4”x1.4”x0.63” (61x36x16 mm)
Weight: 1 oz. (20 gr.)
Battery : 2 x 3V lithium batteries CR2016
÷
65,536
Facility Codes : 256
÷+55°C)
The Transmitter Solutions - 433R receiver which operates with this transmitter has aWiegand 30 bit format output, which willoperate any type of access control system equipped to accept a 30 bit Wiegand input. TheCR 2016 lithium batterieshave a shelf lifeof about 6 months.
Part 15 of FCC Regulations andThe product fully complies with the
European Directives99/5/CE, 89/336/CEE, 73/23/CEE.
1C - Main components
Push-button B
Red LED
Key
holder
ring
Battery
door
Push-button A
6 - TROUBLESHOOTING
Dark Red & White Case
Transmitter
Solutions
Thank you for choosing a Transmitter Solutions product .
Please read this manual carefully before using the product.
Made in Italy.Copyright TransmitterSolutions© 2006 by
Manual
MONARCH 433TSPW2K
2 - NUMBERING
6 - TROUBLESHOOTING
PROBLEM
SOLUTION
The operating range is reduced
Check to verify the
transmitter is programmed
into your system
Replace the transmitter
batteries
To access the battery turn the battery door
. Place the 2 lithium CR2016 batteries into their holder making sure they make contact with the internal ring and withthe positive (+) side of thebattery facingthe back ofthe transmitter.
clockwise
NOTE: Please dispose of the batteries properly according to local laws and regulations. Test proper battery installation by verifying that the red LED illuminates when either button is pushed.
5 - BATTERY ACCESS
3 - PROGRAMMING
Each transmitter is manufactured and sold with a different factory set sequence numberand facilitycode.
The transmitter facility code and sequence number must be programmed intoyour systemmemory. Your owninstaller orreseller will provide youthe necessaryinstructions for yoursystem.
Replace the transmitter
batteries
Transmitter Solutions - Type : SETR2641AM2
FCC ID : PWJT433
This device complies with FCC Rules Operation issubject tothe following twoconditions: (1) Thisdevice maynot cause harmfulinterference, and (2) this device must accept interference received, including interference thatmay causeundesired operation.
Part. 15 of the
The system does not receiver the
transmitter signal.
The transmitter LED is ON
The system does not receiver the
transmitter signal.
The transmitter LED will not light
4 - OPERATION
a. Firmly depresseither button until thesmall redLED illuminates. b. Afterthe LED has illuminated,release the button.If the device youare attempting to activate does not respond, repeat steps a. and b. or consult section6 (Troubleshooting) ofthis manual.
Back of
transmitter
TRANSMITTER SOLUTIONS
2505 Chandler Avenue, Suite, 1
Las Vegas, NV 89120 -
(866) 975-0101 - (866) 975-0404 Fax
sales@transmittersolutions.com
The warranty period of 433 transmitters is 24 months, beginning fromthe manufacturing dateof the transmitter. Duringthis period,if the product doesoperate correctly, dueto a defectivecomponent, the product willbe repaired orreplaced atthe sole discretionof . The warranty does notextend to the transmitter case which can bedamaged by conditions outsidethe controlof or tobattery life.
Transmitter Solutions
TransmitterSolutions
TransmitterSolutions
WARRANTY
Notice
Any changes or modification to equipment not expressly approved by could void themanufacturer’s warranty.
Transmitter Solutions
TransmitterSolutions
IS-TMW433CCUK Rev.1 del 22.05.2006
Loading...