Monaldi White Line ITA Instruction Manual

P

R

O

F

E

S

S

I

O

N

A

L

T

E

A

M

SRL

via Lazio, 9 - 61122 Pesaro Italy tel. [phone] - fax [phone]

www.monaldi.com - [e-mail]

rev. 0.00

INSTRUCTION MANUAL

PLASTIC MENDER mod. ITA

Document protected by copyright. Total or partial reproduction is forbidden.

rev. 0.00

Plastic Mender mod. ITA

INDEX

1 – RAEE regulations

2 – General Safety Precautions

3 – “PLASTIC MENDER” components

4 – Technical specications

5 – Safety and handling

6 – How to operate

7 – Accessories and consumables

1 RAEE Regulations

The symbol on the product or on its packaging indicates that this pro­duct should not be treated as household waste, but it must be handed in
a collection point for the recycling of electrical and electronic equipment.
By disposing of this product appropriately you will help prevent potential
negative consequences that could result from improper disposal of the
product. For more detailed information about recycling of this product,

please contact the municipal ofce, the local waste disposal service or

the shop where you purchased the product.

rev. 0.00

Plastic Mender mod. ITA

2. GENERAL SAFETY PRECAUTIONS

WELDING AND CUTTING CAN BE HARMFUL TO YOURSELF AND OTHERS

The user must therefore be educated against the hazards, summarized below,
deriving from welding operations.

ELECTRIC SHOCK - May be fatal

Install and earth the welding machine according to the regulations.
Do not touch live electrical parts or electrodes with bare skin, gloves or
wet clothing. Make sure your working position is safe. Make sure the circuit
breaker line has been dimensioned according to the power consumption of the
equipment. This switch should intervene in emergency situations. Inspect the
power cord frequently to check its integrity.

FUMES AND GASES - May be hazardous to health

Keep the nose, mouth and eyes away from smoke and noxious fumes.
Work in the presence of adequate ventilation.

RISK OF FIRE AND BURNS

Staples heated can become very hot and burn the skin; you should therefore

make sure there are no ammable materials in the area, and wear appropriate

protective clothing such as gloves and gowns.

NOISE

Do not operate near pressure vessels or in the presence of dust, gases or fu­mes

3. “PLASTIC MENDER” components

– CASE TOOL

– CONTROL BOARD

– HANDLE FOR STAPLES WITH ELECTRIC WIRE

– STAPLES KIT

– MANUAL OF INSTRUCTIONS