Momi Technology M1 User Manual

Wild horses M1

User manual

1、Safety Warning and Transportation Safety
Safety Warning

●For correct and safe use, please read the safety warning carefully
and follow all the instruction .

●When forbidden using wireless device or device use would interrupt
electronic device and safety potential , please turn off the power
supply .

● In flammable and explosive area, please turn off the power supply,
and follow the related instruction, so as not to cause explosion or fire.
Flammable and explosive area include but not limited in: gas station,
fuel section (like: capsule under the ship deck), flammable or heavy
chemicals transport and store device, with explosive danger mark area,
area with the mark of "turn off the two-way wireless electronic device"

Transportation Safety

●When flying on plane , please follow the rule of airline. Turn off the
power supply before the taking off of plane, to avoid the potential risk。

FCC Caution.

This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment

Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or
more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Notes
It will heat slightly when charging or in normal operation, that's normal
phenomenon. Please turn off the switch of power supply when
cleaning the overall unit, and cut off the outer connect.

●Please take good care of the overall unit and its accessories ,and try
to use in tidy environment. Don't let overall unit and its accessories to
contact fire or lighting butt etc.

●Try to keep the product and its accessories dry. Don't contact water
or moisture.

●Please don't fall off, throw or tread.

●Please don't use antistatic soft cloth to clean the overall unit. Don't

use chemicals (like alcohol, benzene etc) chemical washing or frosted
cleaning detergent.

●Please don't put the overall unit and its accessories to too cold or too
hot area.

●Please use our company's authorized accessories .

●Please don't tear down the overall unit, or you could not have the

free guarantee service of our company.

1. Buttons and interface description

2. Bluetooth phone call button, status indicator light

3. MIC port

4. Volume selection, power switch

5. Micro usb port, charge port, line in port

6. Charge indicator light

1. system connection figure

2. Play music on the Bluetooth device

3. Noted: the effective working range between the Bluetooth and M1 is about 10

meters (30 feet)

4. Slide switch ④ to select

the Bluetooth audio source, and then the blue

status indicator light flashes.

5.

Turn on Bluetooth on the device.

6. Select MOMI M1 on the device to pair, when the speaker has “bi”

sound and the blue status indicator light growly flashes, which
means the pairing is successful and it is on the status of standby.