Momentum UPStart User Manual

UP

START

USER

MANUAL

THANK YOU AND WELCOME!

Hello! Thank you for buying Momentum Electric. Excited? We share your excitement but first, please register your bike online
for warranty at http://momentumelectric.com/warranty-registration and read the entire manual carefully before using the
product. If you ever have any questions, please do not hesitate to contact us. We are always ready to help!

[phone] [e-mail] www.momentumelectric.com

THE FINE PRINT

CLEANING THE BIKE

Use a dry or damp towel to clean the bike. Do not use steam or high-pressure cleaners. Do not immerse the bike in water.
When wiping down the battery, do not touch or short circuit the contacts on the underside. Do not immerse the battery in
water. Treat parts liable to corrosion with anti-corrosion agents. Never use cleaning, lubricating or anti-corrosion agents on
the rims as it can drastically reduce the braking performance. Always test the brakes after cleaning and before riding the bike.

IMPORTANT INFORMATION

The bike is designed for public road use. Do not ride o-road or in water. The bike is intended to be used by
only one person. The permitted gross vehicle weight (bike + rider + luggage + towed trailers) is 120kg.
The manual makes no representation about the safe use of the bike under all conditions. Have an initial inspection
carried out by a specialist cycle shop after the first 250km or four to six weeks as the spokes of the wheels will settle,
the brake cables will increase slightly and the bearings will run in during the first weeks of riding. This is important for
the acceptance of claims made under the terms of warranty.
Make sure you know and practice the rules of safe and responsible riding. Read and follow the national legal
requirements of the country where you are riding and comply with all applicable trac laws. When riding in the dark,
wear reflective clothing and use front and rear lights.
In legal terms, the electric bicycle is called EPAC (Electrically Power Assisted Cycles). This means it conforms to the
European product safety standard EN15194 standard of a maximum nominal motor power output of 250W and the
motor switches o above speeds of 25km/h. The electric motor provides assistance as long you are pedalling.
Technical detail and illustrations of this manual are subject to change.

WARRANTY TERMS

The Company warrants that Momentum Electric Products will be free from defect in design, workmanship or materials
in the case of the frame for 5 years and in the case of electricals for 2 years, in each case calculated from the date of
purchase, subject to the following:

• Such warranty excludes normal wear and tear on tyres, brakes, chain, cables and similar parts;

• Momentum Electric Product must have been used in all respects in accordance with the owner’s manual and the
Company’s recommendations and any failure caused or contributed to by non-compliance with the same is excluded;

• Any failure caused or contributed to by any maintenance or repair carried out otherwise than in accordance with
our recommendations is excluded;

• Any failure caused or contributed to by the fitment or use of any part, accessory or other item which is not
recommended by the Company is excluded;

• Notice of claim under the warranty must be received by the Company within the applicable period referred to above;

• The Company’s warranty here is in place of any other warranty, whether express or implied, all of which are
expressly excluded by the Company.

COPYRIGHT NOTICE

No part of this manual may be reproduced, copied,
modified or adapted, without the prior written
consent of the Momentum Electric Limited.

UP2.UM2

CONTACT INFORMATION

Our registered address is:

Momentum Electric Limited
Studio 9
Cornelius Drebbel House
5 Empson Street
London E3 3LT
United Kingdom

R / L

BEFORE FIRST USE

CHARGE THE BATTERY

• Insert the mains plug into an electrical socket and on the battery,
open the charging socket cover and insert the charger plug.

• The charger indicator light will turn red indicating that the
battery is charging; light will turn green when it is fully charged.

• Unplug the battery from the charger plug and close the
charging socket cover.

ASSEMBLE PEDALS

• Look closely at the pedals to identify the right and left
pedals.

• Using a #15 spanner, ax the right pedal by screwing it
clockwise to 30Nm into the right crank .

• From the left side of the bicycle, ax the left pedal by
screwing it anti-clockwise to 30Nm into the left crank.

‘M’ CHECK

• The M Check is a methodical check of the bike in the shape
of the letter M.

• It is good practice to do the M Check before every ride.

• If time is tight, at the very least, check the brakes, tyres,
chain and that the key has been removed before each ride
and do the M Check at least twice a month.

ADJUST SADDLE

• Use the 6mm hex key to loosen the seatpost clamp bolt
to adjust the saddle height.

• Sit on the bike saddle.

• Place one heel on a pedal and push down until it is at the
lowest position. Your leg should be straight.

• Place the balls of your feet on the centre of the pedal.

Your knee should be slightly bent. Tighten seatpost clamp
bolt to 10Nm.

ASSEMBLE HANDLEBARS

• The handlebar must be aligned with the front wheel.

• To do this, loosen the handlebar clamp bolts with the
4mm hex key to adjust the handlebar angle.

• Move the handlebar to be at a perfect right angle to the wheel.

• Use the 4mm hex key to tighten the handlebar clamp
bolt clockwise.

IN THE LITTLE BOX

• Battery charger

• 2 pedals

• #13 / #15 spanner

• 6mm / 5mm / 4mm hex key

• 2 AXA keys