Page 1
Molift Air 200 / 350
Quick guide
QG16601 Rev. A 2020-10-29
Hoist components:
1. Trolley
2. Hoist
3. Side covers
4. Emergency stop/ Emergency
lowering
5. Lifting belt
6. Quick release pin
7. Hand control
8. Sling bar
4
5
6
General information:
Lift and transfer of a client will always pose a certain
risk and only trained personnel are allowed to use the
equipment and accessories covered by this user manual.
The rail system must be installed by certified personnel in
accordance with applicable installation instructions. The
lifter is not intended to be operated by the client being
lifted.
1
2
3
7
8
Battery / Charger indicator:
Wrench symbol / Service
indicator
Battery symbol / Battery
indicator
Only certified personnel are allowed
to open hoist or accessories to perform
service or repair.
Read User Manual before use! This Quick
guide does not replace User Manual. It is
important to fully understand the content
of the user manual before attempting to
use the equipment.
Charger indicator Mode
Green flash Not connected to hoist
Yellow Charging
Yellow flash Top of charge
Green Fully charged
The Hand control has 2 buttons
for lifting and lowering, or 4
buttons if the hoist is equipped
with propulsion. The Hand control
has an indicator light that will illuminate when battery level is low
and the lifter requires charging
Page 2
Lifter installation on trolley in rail
Connect one point first. Push button all the way in,
and place lifter in connection point on trolley. Release
button and make sure it is clearly showing green before
connecting the next point.
Make sure both connection point buttons completely
return and clearly show green after installation.
Emergency lowering cord and tube can be adjusted to
the correct length (height) by cutting tube and cord.
Emergency stop
Pull to activate emergency stop. The button
will come out, and hoist
will stop.
Push with finger or
use tube on cord to
push button back in
to reset emergency
stop.
Electrical emergency lowering
Pull and hold to
start lowering.
Hold until client is
lowered and can be
released from sling
ba r.
Use this checklist to verify that the hoist is properly installed
and can operate correctly and safely before use.
End stops on rail are installed after mounting of trolley
as described in BM4401
Make sure that the hoist is properly fastened to the rail
and that the lift does not have any loose parts.
Perform one lift with load (60-80 kg)
Make sure battery is fully charged.
Mounting suspension
1
2
3 4
Only for emergency use when hand
control does not work!
Lifting and lowering
The sling bars hook design prevents sling to be
inadvertently detached when mounted correct.
1. Align sling bar in connection point.
2. Push button on locking pin and insert all the way through.
3. Make sure locking pin is properly fastened
4. Push and hold down the button on the locking pin, and
pull to remove locking pin.
Loading...