Climbing
With Molift NOMAD it is possible to climb between
two rail systems, and then we can avoid cut-outs
above the doors. There must be a trolley with a
climbing belt present on both rail systems.
• Lower the lifter until it hangs in the climbing
belt only.
The lifter will stop if the lifting belt is untight.
Trolley
Climbing belt
Rail
• Move the lifter until it stops at the end of the
rail, and move the trolley on the opposite side
as close as possible.
Climbing
• Move the lifting belt to the opposite trolley
with the attachment arm.
• Run the lifter up until it hangs in the lifting belt.
The climbing belt can be released, and the lifter
can be run up and down as normal.
belt
Lifting belt
Handle
• Raise the lifter until it is possible to attach the
climbing belt on the opposite trolley to the lifters handle.
Page 11 of 20
Loading...