Molicel MQC-1821B Operating Instructions Manual

E-One Moli Energy (Canada) Limited
20,000 Stewart Crescent
Maple Ridge, B.C. Canada V2X9E7
PH: (604) 466-6654 FAX: (604) 466-6600
www.molienergy.com
R
MQC-1821B
Operating
Instructions
Features
Fully Automatic
Charge status indicator.
Lightweight and small.
Desktop unit.
Safely charges Molicel MCR1821 Lithium-ion battery packs.
Typical charging time, 4-5 hours (MCR1821J).
Powering the Charger
The charger unit should only be powered by the AC adapter supplied with the unit. The rating for the AC adapter is 9 Volt, 700 mA.
Simply plug the AC adapter into a standard wall outlet.
Plug the output plug of the AC adapter into the back of the charger as
identified on figure 1.
When power is correctly applied, the status indicator will be green.
Figure 1
Charging Batteries
The operation of the charger is fully automatic.
Simply place the battery pack into the charger pocket as displayed in
figure 1. Ensure that the two gold contacts on the pack are placed face down into the charger pocket.
The status indicator will change to red to indicate that the charger is charging the battery.
When the battery is fully charged, the status indicator will be green.
The status indicator flashing indicates the operating temperature is out of
range.
Safety Cautions
Only use the charger for charging Molicel, MCR-1821 lithium-ion rechargeable battery packs.
Although the charger may become warm during charging, this is normal and presents no danger.
Do not cover the vents holes in the back of the charger.
For indoors use only. Do not operate around sources of moisture.
Not recommended for use with Molicel, MCR-1821C batteries.
Specifications Input requirements: 9.2 – 12 VDC @ 600 mA min. Charge output: 8.4 VDC @ 550 mA max. Battery type supported: MCR-1821 Molicel Short circuit protection: Built-in protection against accidental
shorting of output contacts
Operating Temperature: 10°C (50°F) to 45°C (112°F)
Weight: 75g External Dimension: 69 mm (W) x 46 mm (H) x 61 mm (T) Approvals: Charger CE
Adapter UL, ULC
Loading...