Moldex 7040 User Manual

Date Printed: 11/5/2018

Safety Data Sheet

www.rustoleum.com

1. Identification

Product Name: MX INST DECK WASH 56 oz H/E Revision Date: 11/5/2018

Product Identifier: 7040 Supercedes Date: 4/26/2018

Recommended Use: Cleaner & Degreaser/ Alkaline

Page 1 / 5

Supplier:

Preparer: Regulatory Department

Emergency Telephone:

Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, IL 60061
USA

24 Hour Hotline: [phone]

Manufacturer:

2. Hazard Identification

Classification

Symbol(s) of Product

Signal Word

Danger

Possible Hazards

7% of the mixture consists of ingredient(s) of unknown acute toxicity.

GHS HAZARD STATEMENTS

Skin Corrosion, category 1B H314 Causes severe skin burns and eye damage.

Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, IL 60061
USA

GHS LABEL PRECAUTIONARY STATEMENTS

P260 Do not breathe dust/fume/gas/mist/vapors/spray.

P264 Wash hands thoroughly after handling.

P280 Wear protective gloves/protective clothing/eye protection/face protection.

P301+P330+P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.

P303+P361+P353 IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/

P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.

P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present

P310 If exposed immediately call a POISON CENTER or doctor/physician.

P321 For specific treatment see label

P405 Store locked up.

P501 Dispose of contents/container in accordance with local, regional and national regulations.

GHS SDS PRECAUTIONARY STATEMENTS

P363 Wash contaminated clothing before reuse.

shower.

and easy to do. Continue rinsing.

Date Printed: 11/5/2018

Page 2 / 5

3. Composition / Information On Ingredients

HAZARDOUS SUBSTANCES

Chemical Name CAS-No. Wt.%

Range

Sodium Hypochlorite 7681-52-9 2.5-10 GHS05 H314

Sodium Hydroxide 1310-73-2 1.0-2.5 GHS05-GHS06 H301-312-314

GHS Symbols

GHS Statements

4. First-Aid Measures

FIRST AID - EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get medical

attention. Do NOT allow rubbing of eyes or keeping eyes closed.

FIRST AID - SKIN CONTACT: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation
develops or persists. Immediately flush skin with plenty of water for at least 15 minutes while removing clothing. Get medical
attention immediately. Wash clothing separately before reuse. Destroy contaminated shoes.

FIRST AID - INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get
immediate medical attention. Do NOT use mouth-to-mouth resuscitation. If you experience difficulty in breathing, leave the area to
obtain fresh air. If continued difficulty is experienced, get medical assistance immediately.

FIRST AID - INGESTION: Swallowing less than an ounce will not cause significant harm. For larger amounts, do not induce
vomiting, but give one or two glasses of water to drink and get medical attention. If swallowed, rinse mouth with water. If feeling
unwell, get medical attention. If swallowed, do not induce vomiting. If victim is conscious and alert, give 2 to 4 cupfuls of water or
milk. Call a physician or poison control center immediately. Never give anything by mouth to an unconscious person. Treat
symptomatically and supportively. Do not induce vomiting unless advised by a physician. Call nearest Poison Control Center or
Physician immediately.

5. Fire-Fighting Measures

EXTINGUISHING MEDIA: None Known

UNUSUAL FIRE AND EXPLOSION HAZARDS: No unusual fire or explosion hazards noted. Keep containers tightly closed. FLASH

POINT IS TESTED TO BE GREATER THAN 200 DEGREES F.

SPECIAL FIREFIGHTING PROCEDURES: Water may be used to cool closed containers to prevent buildup of steam. If water is
used, fog nozzles are preferred. Containers can rupture and release highly toxic material if exposed to heat. Substance is non­combustible but reacts with many metals to form explosive hydrogen gas. Use water spray to keep fire-exposed containers cool.
Containers may explode when heated.

Special Fire and Explosion Hazard (Combustible Dust): No Information

6. Accidental Release Measures

STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: If spilled, contain spilled material and remove with inert

absorbent. Dispose of contaminated absorbent, container, and unused contents in accordance with local, state, and federal
regulations. Do not incinerate closed containersAvoid runoff into sewers and waterways. Provide ventilation and approach spill from
upwind using proper personal protective equipment as indicated in Section 8. Carefully neutralize spill with sodium bicarbonate
(NaHCO3). Dispose of according to local, state (provincial) and federal regulations. Do not incinerate closed containers. Contain
spilled liquid with sand or earth. DO NOT use combustible materials such as sawdust.

7. Handling and Storage

HANDLING: Wash thoroughly after handling. Wash hands before eating. Remove contaminated clothing and launder before reuse.

Use only with adequate ventilation. Follow all SDS and label precautions even after container is emptied because it may retain
product residues. Avoid breathing fumes, vapors, or mist. Avoid contact with eyes, skin and clothing.

STORAGE: Store in a dry, well ventilated place. Keep container tightly closed when not in use.
Advice on Safe Handling of Combustible Dust: No Information

Date Printed: 11/5/2018

8. Exposure Controls / Personal Protection

Page 3 / 5

Chemical Name CAS-No.

Sodium Hypochlorite 7681-52-9 10.0 N.E. N.E. N.E. N.E.
Sodium Hydroxide 1310-73-2 5.0 N.E. N.E. 2 mg/m3 N.E.

PERSONAL PROTECTION

ENGINEERING CONTROLS: Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne

levels below recommended exposure limits. Prevent build-up of vapors by opening all doors and windows to achieve cross­ventilation. Provide general dilution of local exhaust ventilation in volume and pattern to keep TLV of hazardous ingredients below
acceptable limits.

RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant a respirator's use.

SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin protection.
Use impervious gloves to prevent skin contact and absorption of this material through the skin.

EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.

OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further guidance regarding types of

personal protective equipment and their applications.

HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.

Engineering Measures for Combustible Dust: No Information

Weight %

Less Than

ACGIH TLV-

TWA

ACGIH TLV-

STEL

OSHA PEL-TWA

OSHA PEL-

CEILING

9. Physical and Chemical Properties

Appearance:
Odor:
Relative Density:
Freeze Point, °C:
Solubility in Water:
Decompostion Temp., °C:
Boiling Range, °C:
Flammability:
Evaporation Rate:
Vapor Density:

Liquid
Mild

1.093
N.D.
Soluble
N.D.
100 - 104
Does not Support Combustion
Slower than Ether
Heavier than Air

Physical State:
Odor Threshold:
pH:
Viscosity:
Partition Coefficient, n-octanol/

water:

Explosive Limits, vol%:
Flash Point, °C:
Auto-ignition Temp., °C:
Vapor Pressure:

Liquid
N.E.
10 - 12
N.D.

N.D.

N.A. - N.A.
94
N.D.
N.D.

(See "Other information" Section for abbreviation legend)

10. Stability and Reactivity

CONDITIONS TO AVOID: Avoid contact with metals.

INCOMPATIBILITY: Incompatible with strong oxidizing agents, strong acids and strong alkalies. Product slowly corrodes copper,

aluminum, zinc, and galvanized surfaces.

HAZARDOUS DECOMPOSITION: When heated to decomposition, it emits acrid smoke and irritating fumes. Decomposition
produces hydrogen chloride, chlorine and hydrogen gases.

HAZARDOUS POLYMERIZATION: Will not occur under normal conditions.

STABILITY: This product is stable under normal storage conditions.

11. Toxicological Information

EFFECTS OF OVEREXPOSURE - EYE CONTACT: Irritating, and may injure eye tissue if not removed promptly. Substance causes

severe eye irritation. Injury may be permanent.

EFFECTS OF OVEREXPOSURE - SKIN CONTACT: Low hazard for usual industrial handling or commercial handling by trained
personnel. Severely irritating; may cause permanent skin damage.

EFFECTS OF OVEREXPOSURE - INHALATION: High gas, vapor, mist or dust concentrations may be harmful if inhaled. Avoid
breathing fumes, spray, vapors, or mist. Harmful if inhaled. High vapor concentrations are irritating to the eyes, nose, throat and
lungs.

EFFECTS OF OVEREXPOSURE - INGESTION: Substance may be harmful if swallowed. Corrosive and may cause severe and

Date Printed: 11/5/2018

permanent damage to mouth, throat and stomach.

EFFECTS OF OVEREXPOSURE - CHRONIC HAZARDS: Repeated exposure to low concentrations of HCl vapor or mist may cause
bleeding of nose and gums.

PRIMARY ROUTE(S) OF ENTRY: Eye Contact, Ingestion, Inhalation, Skin Absorption, Skin Contact

ACUTE TOXICITY VALUES
The acute effects of this product have not been tested. Data on individual components are tabulated below:

CAS-No.

7681-52-9 Sodium Hypochlorite 8910 mg/kg Rat >10000 mg/kg Rabbit N.E.
1310-73-2 Sodium Hydroxide 140 - 340 mg/kg Rat 1350 mg/kg Rabbit N.E.

N.E. - Not Established

Chemical Name Oral LD50 Dermal LD50 Vapor LC50

Page 4 / 5

12. Ecological Information

ECOLOGICAL INFORMATION: Product is a mixture of listed components.

13. Disposal Information

DISPOSAL INFORMATION: Dispose of material in accordance to local, state, and federal regulations and ordinances. Do not allow

to enter waterways, wastewater, soil, storm drains or sewer systems. RCRA Hazardous Waste: This material, when discarded or
disposed of, could be a hazardous waste according to federal regulations (40 CFR 261) due to the characteristic of corrosivity (D002).
Check state and local regulations for disposal requirements. Chemical additions, processing or otherwise altering this material may
make the waste management information presented in this SDS incomplete, inaccurate, or otherwise inappropriate.

14. Transport Information

Domestic (USDOT) International (IMDG) Air (IATA) TDG (Canada)

UN Number: N.A. N.A. N.A. N.A.

Proper Shipping Name: Not Regulated Not Regulated Not Regulated Not Regulated

Hazard Class: N.A. N.A. N.A. N.A.

Packing Group: N.A. N.A. N.A. N.A.

Limited Quantity: No No No No

15. Regulatory Information

U.S. Federal Regulations:

CERCLA - SARA Hazard Category

This product has been reviewed according to the EPA ‘Hazard Categories’ promulgated under Sections 311 and 312 of the
Superfund Amendment and Reauthorization Act of 1986 (SARA Title III) and is considered, under applicable definitions, to
meet the following categories:

Skin Corrosion or Irritation

Sara Section 313:

This product contains the following substances subject to the reporting requirements of Section 313 of Title III of the
Superfund Amendment and Reauthorization Act of 1986 and 40 CFR part 372:

No Sara 313 components exist in this product.

Toxic Substances Control Act:

This product contains the following chemical substances subject to the reporting requirements of TSCA 12(b) if exported from
the United States:

No TSCA 12(b) components exist in this product.

Date Printed: 11/5/2018

U.S. State Regulations:

California Proposition 65:

WARNING: No Prop. 65 warning is required.

16. Other Information

HMIS RATINGS

Health: 2* Flammability: 0 Physical Hazard: 0 Personal Protection: X

NFPA RATINGS

Health: 2 Flammability: 0 Instability 0

Volatile Organic Compounds 0 g/L

SDS REVISION DATE: 11/5/2018

REASON FOR REVISION: Substance and/or Product Properties Changed in Section(s):

02 - Hazard Identification
15 - Regulatory Information
16 - Other Information
Revision Statement(s) Changed

Legend: N.A. - Not Applicable, N.E. - Not Established, N.D. - Not Determined

Page 5 / 5

The manufacturer believes, to the best of its knowledge, information and belief, the information contained herein to be accurate
and reliable as of the date of this safety data sheet. However, because the conditions of handling, use, and storage of these
materials are beyond our control, we assume no responsibility or liability for personal injury or property damage incurred by the
use of these materials. The manufacturer makes no warranty, expressed or implied, regarding the accuracy or reliability of the
data or results obtained from their use. All materials may present unknown hazards and should be used with caution. The
information and recommendations in this material safety data sheet are offered for the users’ consideration and examination. It is
the responsibility of the user to determine the final suitability of this information and to comply with all applicable international,
federal, state, and local laws and regulations.