Moldex 7010 User Manual

Date Printed: 4/17/2019

Safety Data Sheet

1. Identification

Page 1 / 5

www.rustoleum.com

Product Name:

Product Identifier: 7010 Supercedes Date: 4/8/2019

Recommended Use: Cleaner & Degreaser/Alkaline

Supplier:

Preparer: Regulatory Department

Emergency Telephone:

MX INST MOLD & MILDW STN RMVR 32 oz
SPRAY

Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, IL 60061
USA

24 Hour Hotline: [phone]

Revision Date: 4/17/2019

Manufacturer:

Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, IL 60061
USA

2. Hazard Identification

Classification

Symbol(s) of Product

Signal Word

Danger

GHS HAZARD STATEMENTS

Skin Corrosion, category 1B H314 Causes severe skin burns and eye damage.

GHS LABEL PRECAUTIONARY STATEMENTS

P260 Do not breathe dust/fume/gas/mist/vapors/spray.

P264 Wash hands thoroughly after handling.

P280 Wear protective gloves/protective clothing/eye protection/face protection.

P301+P330+P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.

P303+P361+P353 IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/

P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.

P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present

P310 If exposed immediately call a POISON CENTER or doctor/physician.

P321 For specific treatment see label

P405 Store locked up.

P501 Dispose of contents/container in accordance with local, regional and national regulations.

GHS SDS PRECAUTIONARY STATEMENTS

P363 Wash contaminated clothing before reuse.

shower.

and easy to do. Continue rinsing.

Date Printed: 4/17/2019

Page 2 / 5

3. Composition / Information On Ingredients

HAZARDOUS SUBSTANCES

Chemical Name CAS-No. Wt.%

Range

Sodium Hypochlorite 7681-52-9 2.5-10 GHS05 H314

Sodium Hydroxide 1310-73-2 0.1-1.0 GHS05-GHS06 H301-312-314

GHS Symbols

GHS Statements

4. First-Aid Measures

FIRST AID - EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get medical

attention. Do NOT allow rubbing of eyes or keeping eyes closed.

FIRST AID - SKIN CONTACT: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation
develops or persists. Immediately flush skin with plenty of water for at least 15 minutes while removing clothing. Get medical
attention immediately. Wash clothing separately before reuse. Destroy contaminated shoes.

FIRST AID - INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get
immediate medical attention. Do NOT use mouth-to-mouth resuscitation. If you experience difficulty in breathing, leave the area to
obtain fresh air. If continued difficulty is experienced, get medical assistance immediately.

FIRST AID - INGESTION: If swallowed, rinse mouth with water. If feeling unwell, get medical attention. Swallowing less than an
ounce will not cause significant harm. For larger amounts, do not induce vomiting, but give one or two glasses of water to drink and
get medical attention. If swallowed, do not induce vomiting. If victim is conscious and alert, give 2 to 4 cupfuls of water or milk. Call a
physician or poison control center immediately. Never give anything by mouth to an unconscious person. Treat symptomatically and
supportively. Do not induce vomiting unless advised by a physician. Call nearest Poison Control Center or Physician immediately.

5. Fire-Fighting Measures

EXTINGUISHING MEDIA: Alcohol Film Forming Foam, Carbon Dioxide, Dry Chemical, Dry Sand, Water Fog

UNUSUAL FIRE AND EXPLOSION HAZARDS: Keep containers tightly closed. FLASH POINT IS TESTED TO BE GREATER THAN

200 DEGREES F. No unusual fire or explosion hazards noted.

SPECIAL FIREFIGHTING PROCEDURES: Water may be used to cool closed containers to prevent buildup of steam. If water is
used, fog nozzles are preferred. Containers can rupture and release highly toxic material if exposed to heat. Substance is non­combustible but reacts with many metals to form explosive hydrogen gas. Use water spray to keep fire-exposed containers cool.
Containers may explode when heated.

Special Fire and Explosion Hazard (Combustible Dust): No Information

6. Accidental Release Measures

STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: If spilled, contain spilled material and remove with inert

absorbent. Dispose of contaminated absorbent, container, and unused contents in accordance with local, state, and federal
regulations. Do not incinerate closed containersAvoid runoff into sewers and waterways. Provide ventilation and approach spill from
upwind using proper personal protective equipment as indicated in Section 8. Carefully neutralize spill with sodium bicarbonate
(NaHCO3). Contain spilled liquid with sand or earth. DO NOT use combustible materials such as sawdust. Dispose of according to
local, state (provincial) and federal regulations. Do not incinerate closed containers.

7. Handling and Storage

HANDLING: Wash thoroughly after handling. Wash hands before eating. Remove contaminated clothing and launder before reuse.

Use only with adequate ventilation. Follow all SDS and label precautions even after container is emptied because it may retain
product residues. Avoid breathing fumes, vapors, or mist. Avoid contact with eyes, skin and clothing.

STORAGE: Store in a dry, well ventilated place. Keep container tightly closed when not in use.
Advice on Safe Handling of Combustible Dust: No Information