Moffat, Inc. PW1 General Manual

PW1 High Performance Potwasher

The front loading PW1 has a wash compartment 565 wide by 595
deep by 750mm high, which includes a rail for hanging whisks and
ladles.

Ideal for washing a widerangeofbins,dixies,utensils, baking trays and
mixing bowls - typicallyupto 80 litres.

Operator may select 2, 4 or 6 minute cycles for rapid washing of a wide
range of soil levels. Regardless of cycle time the high temperature
sanitising rinse uses only about 3 litres of water per cycle to ensure
highly efficient operation, minimising water, waste, power and chemical
costs.

The 1.5 kW wash pump recirculates 800 litres of water per minute
through double upper and lower wash arms for exceptional wash
performance. Double filtration in the deep L shape wash tank isolates
solid soil on easily removablescrap trays.

Powerful rinse boosterelements ensure rapid recovery between cycles
for high capacity.

PW1

PW1

HIGH PERFORMANCE POTWASHER

Counterbalanced insulated two piece doorwith safety stop switch.

Easy to keep clean with FASTCLEAN rounded wash tank, uncluttered
internal design, doublefiltration, scrap trays, and all stainless wash and
rinse arms with removable endplugs.

Electrical requirement forthe new series 3 PW1 is 15 amps per phase 3
phase, neutral and earth.

Supplied with one 500mm openrack with cover.

20

595

WaterMark

ATS5200.101

Cert 08603

SAI GLOBAL

750

TM

565

Wash Chamber

Over 25 years Washtech has earned the position of
Australasia's leadingwash equipmentmanufacturer
by providing robust, reliable machines designed for
ease of service and years of effective, efficient
operation.

ISO 9001 certified and audited since 1993 - our
equipment complies with all local hygiene, electrical
and plumbingregulations includingWATERMARK.

Washtech products are supported nationwide by the
MOFFAT Service Network to ensure long term
access to parts and after sales support and service
including preventativemaintenance programmes.

2,4,6

3.5

750

15A

3

500

330

Installation drawing and detail overleaf.

Australia Moffat Pty Limited

www.moffat.com.au

24 HOUR SERVICE

1800 622 216

REPLACEMENT PARTS

1800 337 963

Victoria/Tasmania
740 Springvale Road
Mulgrave, Victoria 3170
Telephone [phone]
Facsimile 03 9518 3833
Email [e-mail]
www.moffat.com.au

In linewith policyto continuallydevelop and improve
it's products Moffat reserves the right to change
specifications anddesign withoutnotice.

New South Wales
Telephone [phone]
Email [e-mail]

South Australia
Telephone [phone]
Email [e-mail]

24

6

18

12

7

SERVICE & SUPPORT

Queensland
Telephone [phone]
Email [e-mail]

Western Australia
Telephone

08 9202 6820

Email

[e-mail]

Effective November 2007

PW1 High Performance Potwasher

PW1

Installer must be suitably qualified and ensure
compliance with all local codes and standards
including AS/NZS 3500.1. Failure to comply even
partially with installation instructions may void the
warranty. Install machine on sound waterproof self­draining floor and use adjustable feet to level
machine. Allow room for detergent to one side of
machine or in adjacent cupboard. 20 litre container
requires about 450H x 250W x 350D, but smaller
containers are available from manysuppliers.

Water Supply

Water temperature 65°C ± 5°C
Connection 20 mm (3/4" BSP) male
Pressure 200-350 kPa = 30-50 psi
Flow rate minimum 20litres per minute
Hot water consumption 3,5 litres per cycle approx
Backflow prevention Dual Check Valve supplied

Pressure limiter may be required. Don't use small
diameter plastic supply lines. FLUSH supply line
before connection. Poor quality supply or excessive
water hardness may affect performance or damage
machine - filtration and/or softening is
recommended. Optional rinse booster pump
available for very low pressuresupply.

Waste

40mm gravity drain - refer to point B in the
installation diagram - run waste directly behind the
machine or hole in base.

Power

Electrical supply required is 3 Phase, Neutral and
Earth, 15A/Ph, 415V, 50Hz permanently wired via
wall switch mounted adjacent to the machine.
Wash pump rotation must be checked after
installation to ensure correct direction (excessive
noise and damage with incorrectdirection)

Detergent

If detergent pump is fitted insert pump inlet hose into
container of commercial low foam detergent. Open
machine door and switch machine on. Press and
hold detergent prime switch behind front cover until
chemical flows into machine. Commercial
detergents can be hazardous - read instructions and
handle with care.