Moffat Washers Owner's Manual

Washers
175D1807P573 49-90305-1 09-06 JR
Safety Instructions . . . . . . . . . .2, 3
Operating Instructions
Care and Cleaning
of the Washer . . . . . . . . . . . . . . . . . . . . 7
Control Panel . . . . . . . . . . . . . . . . . . . . . .4
Control Settings . . . . . . . . . . . . . . . .4, 5
Loading and Using
the Washer . . . . . . . . . . . . . . . . . . . . . . . 7
Troubleshooting Tips . . . . . .8–10
Consumer Support
Consumer Support . . . . . . . . . . . . . . .12
Warranty . . . . . . . . . . . . . . . . . . . . . . . .11
Write the model and serial number here:
Model # ______________
Serial # ______________
You can find them under the lid of the washer.
Owner’s Manual
2
Install or store where it will not be exposed to temperatures below freezing or exposed to the weather, which could cause permanent damage and invalidate the warranty.
Properly ground washer to conform with all governing codes and ordinances. Follow details in Installation Instructions.
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING.
WARNING!
For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life.
WATER HEATER SAFETY
Under certain conditions, hydrogen gas may be produced in a water heater that has not been used for two weeks or more. Hydrogen gas can be explosive under these circumstances.
If the hot water has not been used for two weeks or more, prevent the possibility of damage or injury by turning on all hot water faucets and allowing them to run for several minutes. Do this before using any electrical appliance which is connected to the hot water system. This simple procedure will allow any built-up hydrogen gas to escape. Since the gas is flammable, do not smoke or use an open flame or appliance during this process.
PROPER INSTALLATION
This washer must be properly installed and located in accordance with the Installation Instructions before it is used. If you did not receive an Installation Instructions sheet, you can receive one by calling, toll-free, 1.800.361.3400
.
YOUR LAUNDRY AREA
Keep the area underneath and around your appliances free of combustible materials such as lint, paper, rags, chemicals, etc.
Close supervision is necessary if this appliance is used by or near children. Do not allow children to play on, with or inside this or any other appliance.
Operating Instructions Safety Instructions
Consumer Support
Troubleshooting Tips
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
3
Use this appliance only for its intended purpose as described in this Owner’s Manual.
WHEN USING THE WASHER
Never reach into washer while it is moving. Wait until the machine has completely stopped before opening the lid.
Do not mix chlorine bleach with ammonia or acids such as vinegar and/or rust remover. Mixing different chemicals can produce a toxic gas which may cause death.
Do not wash or dry articles that have been cleaned in, washed in, soaked in or spotted with combustible or explosive substances (such as wax, oil, paint, gasoline, degreasers, dry-cleaning solvents, kerosene, etc.). These substances give off vapors that may ignite or explode. Do not add these substances to the wash water. Do not use or place these substances around your washer or dryer during operation.
The laundry process can reduce the flame retardancy of fabrics. To avoid such a result, carefully follow the garment manufacturer’s wash and care instructions.
To minimize the possibility of electric shock, unplug this appliance from the power supply or disconnect the washer at the building’s distribution panel by removing the fuse or switching off the circuit breaker before attempting any maintenance or cleaning.
NOTE: Turning the Cycle Selector Knob to an off position, or pressing PAUSE does NOT disconnect the appliance from the power supply.
Never attempt to operate this appliance if it is damaged, malfunctioning, partially disassembled, or has missing or broken parts, including a damaged cord or plug.
WHEN NOT IN USE
Turn off water faucets to relieve pressure on hoses and valves and to minimize leakage if a break or rupture should occur. Check the condition of the fill hoses; they should be replaced every 5 years.
Before discarding a washer, or removing it from service, remove the washer lid to prevent children from hiding inside.
Do not attempt to repair or replace any part of this appliance unless specifically recommended in this Owner’s Manual, or in published user-repair instructions that you understand and have the skills to carry out.
Do not tamper with controls.
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
SAVE THESE INSTRUCTIONS
4
• Add detergent
• Add diluted fabric softener (on models with a fabric softener dispenser)
• Add clothes
• Select load size and other wash options
• Select wash cycle
• Close lid
• Pull knob
Quick Start Guide
About the control panel.
Load Size (on some models)
Loosely load clothes no higher than the top row of holes in the washer basket. The water level should just cover the clothes. Adjust the load size accordingly.
Temperature (on some models)
Select the water temperature for the wash and rinse cycles. Always follow fabric manufacturer’s care label or instructions when laundering.
Extra Rinse (on some models)
When you use extra detergent or bleach to clean heavily soiled clothes, you may want to use the Extra Rinse option.
This option provides a second deep cold rinse in the COTTONS and WRINKLE FREE cycles. Turn the Extra Rinse knob to ON.
The washer will pause for a few minutes before the Extra Rinse option begins.
A
A
B
B
C
C
D
Step 1
Step 2
Step 3
Step 4
Controls
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
Wash Cycle—Cycle Selector Knob
The chart below will help you match the wash cycle setting with your clothing. The chart is ranked from longest to shortest cycle time and wash intensity.
Your washer may not have all these cycles.
PREWASH For removing surface dirt from heavily soiled clothes. Make sure to follow with a
regular wash cycle.
COTTONS For heavy to lightly soiled cottons, household linens, work and play clothes.
WRINKLE FREE For easy care, wrinkle-free and permanent press items.
DELICATES For lingerie and special-care fabrics with light to normal soil.
KNITS Specially designed for normally soiled knits.
Custom Care (on some models)
The agitator moves clothes around for a cleaner wash; the basket spins later in the cycle to release water from the load. The Wash/Spin Speed dial sets the speed of both the agitator and the basket.
Wash Speeds:
With Normal wash speed, the agitator will move at a higher speed. Use for cottons, denims and play clothes. With Gentle wash speed, the agitator moves slower. Use for delicate and knit items.
Spin Speeds:
The Fast spin speed is for normal items. Use it to remove more water from your clothes to allow them to dry faster in the dryer.
The Slow spin speed is for delicate items like sweaters and lingerie. When using Slow spin speed, clothes will be less dry than when using Fast spin speed.
D
5
Operating Instructions Safety Instructions
Consumer Support
Troubleshooting Tips
6
Separate for cleaning
About washer features.
Cleaning the Fabric Softener Dispenser (on some models)
Remove the dispenser from the top of the agitator.
Separate the dispenser cup from the cover by grasping the top and pushing down on the inside of the cup with your fingers. Dispenser cup will pop free from the cover.
To clean the dispenser, soak both the dispenser cup and the dispenser cover in the following solution:
1 US gallon (3.8 liters) warm water
1/4 cup (60 ml) heavy-duty liquid detergent
1 cup (240 ml) bleach
If necessary, loosen buildup with a clean, soft cloth after soaking. Do not use a stiff brush; you may roughen the surface of the dispenser.
Rinse and reassemble dispenser. Place dispenser back on the agitator.
5
4
3
2
1
The Agitator Cap or Fabric Softener Dispenser (depending on model)
The agitator cap fits into the top of the
agitator. If it accidentally comes off, simply put it back on.
The fabric softener dispenser automatically releases liquid fabric softener at the proper time during the cycle.
Do not stop the washer during the first spin. This will cause the dispenser to empty too soon.
To use, follow these steps:
Make sure dispenser is securely attached to agitator.
Use only liquid fabric softener. Pour into dispenser, using amount recommended on package.
Never pour fabric softener directly on clothes. It may stain them.
Add water to dispenser until it reaches the maximum fill line.
3
2
1
Do not pour anything into the agitator if the agitator cap or dispenser is removed.
Liquid Bleach Funnel (on some models)
The water fill dilutes liquid chlorine bleach as the washer fills for the wash cycle.
Check clothing care labels for special instructions.
Measure liquid bleach carefully, following instructions on the bottle.
Never pour undiluted liquid chlorine bleach directly onto clothes or into the wash basket.
Do not pour powdered bleach into bleach funnel.
Before starting the washer, pour measured amount of bleach directly into bleach funnel. Avoid splashing or over-filling dispenser. If you prefer to use powdered bleach, add it into the wash basket with your detergent.
Do not mix chlorine bleach with ammonia or acids such as vinegar and/or rust remover. Mixing can produce a toxic gas which may cause death.
3
2
1
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
7
Loading and using the washer.
Always follow fabric manufacturer’s care label when laundering .
Sorting Wash Loads
Sort by color (whites, lights, colors), soil level, fabric type (sturdy cottons, easy care, delicates) and whether the fabric produces lint (terry cloth, chenille) or collects lint (velveteen, corduroy).
Proper Use of Detergent
Add detergent and start the washer before adding clothes so that the detergent can work effectively. Using too little or too much detergent is a common cause of laundry problems.
You can use less detergent if you have soft water, a smaller load or a lightly soiled load.
Loading the Washer
Load dry items loosely, no higher than the top row of holes in the washer basket. When loading wet items, make sure you set the load/water level high enough to allow the items to move freely. Water level should just cover the clothes. To add items after washer has started, lift the lid and submerge additional items next to the agitator.
Do not wrap long items like sheets or pants around the agitator.
Do not wash fabrics containing flammable materials (waxes, cleaning fluids, etc.).
Agitation will not start with the lid up.
Wash Basket: Leave the lid open after washing to allow moisture to evaporate. If you want to clean the basket, use a clean soft cloth dampened with liquid detergent; then rinse. (Do not use harsh or gritty cleaners.)
Fill Hoses: Hoses connecting washer to faucet should be replaced every 5 years.
Exterior: Immediately wipe off any spills. Wipe with damp cloth. Try not to hit surface with sharp objects.
Moving and Storage: Ask the service technician to remove water from drain pump and hoses. See the Installation Instructions packed with product for information on how to reinstall the shipping rod to keep the tub stationary when moving the washer. For more information, call 1.800.361.3400. Do not store the washer where it will be exposed to the weather.
Long Vacations: Be sure water supply is shut off at faucets. Drain all water from hoses if weather will be below freezing.
Care and cleaning of the washer.
Operating Instructions Safety Instructions
Consumer Support
Troubleshooting Tips
PERFECTEMP Possible Causes What To Do
PerfecTemp The washer is in a cold This is normal. The PerfecTemp feature is designed not wash temperature rinse cycle to activate during a cold rinse cycle to improve the energy is incorrect efficiency of your washer.
(Review PerfecTemp All the water in your Wait until the water in the water heater is heated to the in the “About washer household water heater correct temperature. features” section) has been used
WATER Possible Causes What To Do
Too many suds Too much detergent Measure your detergent carefully. Use less soap if you have
soft water, a smaller load or a lightly soiled load.
Type of detergent Switch to a lower sudsing detergent brand and follow
instructions on package.
Soft water Try less detergent.
Water leaks Using too much detergent Use less detergent. Use less soap if you have soft water,
in washer a smaller load or a lightly soiled load.
Fill hoses or drain hose is Make sure hose connections are tight at faucets and improperly connected rubber washers are installed. Make sure end of drain hose
is correctly inserted in and secured to drain facility.
Household drain may Check household plumbing. You may need to call be clogged a plumber.
Constant water pressure Tighten hoses at the faucets and turn the water off after to the fill hoses at the each use. water source
Check condition of the fill hoses; they should be replaced
every 5 years.
Water temperature Cooler water temperatures New laundry detergents have been formulated to work seems incorrect provide improved energy with cooler water temperatures without affecting wash
efficiency performance.
Water supply is turned off Turn both hot and cold faucets fully on and make sure or improperly connected hoses are connected to correct faucets.
Water valve screens are Turn off the water source and remove the water connection stopped up hoses from the upper back of the washer. Use a brush or
toothpick to clean the screens in the machine. Reconnect the hoses and turn the water back on.
House water heater is Make sure house water heater is delivering water at not set properly 120°F–140°F (48°C–60°C).
Water pumped out before Lid lifted or cycle was put in Reset cycle. cycle is complete pause for over 24 hours
Water won’t drain Drain hose is kinked or Straighten drain hose and make sure washer is not
improperly connected sitting on it.
Top of drain outlet should be less than 8 ft (2.5 m)
above floor.
Washer pauses during The PREWASH Cycle or This is normal. The washer alternates between agitate and wash cycle AUTO SOAK Option was soak during these cycles to get your clothes cleaner with
chosen less wear.
Washer pauses during This is normal The washer may pause during the spin cycle to remove spin cycle soapy water more efficiently.
Troubleshooting Tips Save time and money! Review the charts on the following pages
and you may not need to call for service.
Before you call for service…
8
Loading...
+ 16 hidden pages