Moffat RN8110GC User Manual

Technical data sheet for

TARGET TOP GAS CONVECTION
OVEN RANGE 900mm

RN8110GC

Heavy-duty cast iron top with removable

centre ring

Matched modular height machined top for

seamless work surface

High output dual ring cast iron burner

GN 2/1 gas convection oven

Drop down door

Stainless steel exterior

Easy clean

Easy service

Fully modular

Overall Construction

• Galvanized steel chassis

• Welded hob surround with 1.5mm 304 stainless steel bull nose

• Splashback and hob sides 1.2mm 304 stainless steel

• Front panels and oven sides 0.9mm 304 stainless steel

• 150mm legs in 63mm dia. heavy-duty 1.2mm 304 stainless steel with
adjustable feet

Targe t t op

• 3 piece heavy-duty cast iron top with fully machined surface

• Top plates and removable centre with integral spill protection design

• Cast top reinforced with integral heat fins for heat zone definition

• 45MJ dual ring cast iron burner with single control

• Full pilot and flame failure protection

• 50mm thick refractor y brick lined burner box for high heat retention

• 2 vitreous enamelled spill trays

• Supplied with heavy-duty centre casting removal tool

Oven

• Fully welded and vitreous enamelled oven liner

• GN 2/1 capacity with 4 position racking

• Heavy-duty easy remove heav y wire chrome rack supports

• Cast iron even heat oven sole plate

• 30MJ oven burner

• Pilot and flame failure with piezo ignition

• 100W heavy duty motor

• 200mm diameter heavy-duty circulation fan

• Welded frame drop down do or with heavy-dut y spring hinge system

• 0.9mm 304 stainless steel door outer

• 1.0mm press formed vitreous enamelled door inner

• High density fibreglass insulated

• Stay cool stainless steel door handle with cast metal handle mounts

• Supplied with two chrome wire oven racks

Controls

• Large easy use control knobs - heat resistant reinforced

• Easy view control settings on knobs

Targe t t op

• Variable high to low burner control

• Single control knob for burner and pilot system

• Flame failure pilot burner

• Manual pilot ignition for reliable operation

Oven

• 50-320˚C thermostatic control

• Indicator lights for power and heating

• Piezo ignition to pilot burner

• Flame failure

• Fan and burner automatic off when door open

Cleaning and Servicing

• Removable oven racking and sole plate

• Easy clean vitreous enamel oven and door inner

• Easy clean stainless steel exterior

• Target Top fully serviceable from front of unit

• Bottom sill removable for burner and pilot access

• Door hinge spring adjustable on unit (door outer removed)

• Door disengages for lift off removal and increased service access

• Access to all parts from front of unit

Technical data sheet for

TARGET TOP GAS CONVECTION
OVEN RANGE 900mm

Specifications

Burners

45MJ dual ring cast iron - Target Top
30MJ tubular - Oven

Gas power

75MJ/hr, 20.8kW

Oven Fan Motor

100W

Electrical requirements

0.13kW
230-240Vac, 50/60hz, 1P+N+E, 0.6A

Tar get Top

Cooking surface 900mm x 625mm, 5625cm2
Centre 280mm diameter
Maximum plate temperature at centre 500˚ C

Oven Dimensions

Width 665mm
Depth 590mm
Height 385mm
Rack size 660mm x 540mm
Rack positions 4

Gas connection

3

/4 (BSP) male

R
130mm from RH side, 31mm from rear,

and 655mm from floor
Optional underside connection

(refer specification drawing)
All units supplied with Natural and LP gas

regulator

Electrical connection

23mm from RH side, 484mm from rear,
and 150mm from floor

Power cord with 10A 3 pin plug fitted

Dimensions

Width 900mm
Depth 805mm
Height 915mm
Incl. splashback 1130mm

Pack ing data

1.02m3
Width 940mm
Depth 865mm
Height 1255mm

Gas types

Available in Natural gas and LP gas
Please specif y when ordering
Units supplied complete with gas type

conversion kits
Other gas types on request

Options at extra cost

Joining caps
Castors
Plinth mounting

RN8110GC

Australia

www.moffat.com.au

New Zealand

www.moffat.co.nz

Australia
Moffat Pty Limited

Victoria/Tasmania

740 Springvale Road
Mulgrave, Victoria 3170
Telephone [phone]
Facsimile 03-9518 3833
[e-mail]

New South Wales

Telephone [phone]
[e-mail]

South Australia

Telephone [phone]
[e-mail]

Queensland

Telephone [phone]
[e-mail]

Western Australia

Telephone [phone]
[e-mail]

New Zealand
Moffat Limited

Christchurch

Telephone [phone]
[e-mail]

Auckland

Telephone [phone]
[e-mail]

ISO9001

Quality
Management
Standard

Designed and manufactured by

ISO9001
All Waldorf products are designed and
manufactured by Moffat using the
internationally recognised ISO9001 quality
management system, covering design,
manufacture and final inspection, ensuring
consistent high quality at all times.

In line with policy to continually develop and
improve its products, Moffat Limited reserves
the right to change specifications and design
without notice.

Printed in New Zealand

© Copyright Mo ffat Limited

Moffat/4639/BH/1M/8.05