Moffat MWR02 Owner's Manual

Safety Instructions ............2, 3

Installation Instructions ........4

Owner’s Manual

and Installation

Operating Instructions

Control Settings .....................5

Care and Cleaning ..............6

Troubleshooting Tips .........8, 9

Consumer Support

Product Registration ................11

Warranty ..........................13

Consumer Support .................14

MWR02

Write the model and serial
numbers here:

Model # ______________________

Serial # _______________________

Find these numbers on the Rating
Plate located either inside the or

Wine Chiller

outside on the rear wall of the
Wine Chiller.

Part No. 350A4502P750 01/14 ATS

IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.

Safety Instructions

Installation

Instructions

WARNING!

Use this appliance only for its intended purpose as described in this Owner’s Manual.

SAFETY PRECAUTIONS

When using electrical appliances, basic safety precautions should be followed, including
the following:

This wine chiller must be properly installed and

located in accordance with these instructions
before it is used.

Do not allow children to climb, stand or hang

on the shelves in the wine chiller. They could
damage the wine chiller and seriously injure
themselves.

Keep fingers out of the “pinch point” areas;

clearances between the doors and between
the doors and cabinet are necessarily small.
Be careful closing doors when children are
in the area.

Unplug the wine chiller before cleaning and

making repairs.

Operating

Instructions

Care and Cleaning

Do not store or use gasoline or other flammable

vapors and liquids in the vicinity of this or any
other appliance.

NOTE: We strongly recommend that any
servicing be performed by a qualified individual.

Do not store or install this appliance outdoors.

DANGER! RISK OF CHILD ENTRAPMENT

PROPER DISPOSAL OF THE WINE CHILLER

Child entrapment and suffocation are not
problems of the past. Junked or abandoned
refrigeration products are still dangerous…
even if they will sit for “just a few days.”
If you are getting rid of your old appliance, please
follow the instructions below to help prevent
accidents.

Before You Throw Away Your Old
Refrigeration Product:

Take off the doors.

Leave the shelves in place so that children

may not easily climb inside.

CFC Disposal

Your old refrigerator has a cooling system that
used CFCs (chlorofluorocarbons). CFCs are believed
to harm stratospheric ozone.

If you are throwing away your old refrigerator,
make sure the CFC refrigerant is removed for
proper disposal by a qualified servicer. If you
intentionally release this CFC refrigerant, you
can be subject to fines and imprisonment under
provisions of environmental legislation.

USE OF EXTENSION CORDS

Because of potential safety hazards under certain conditions, we strongly recommend against
the use of an extension cord.

However, if you must use an extension cord, it is absolutely necessary that it be CSA certified, 3-wire
grounding type appliance extension cord having a grounding type plug and outlet and that the electrical
rating of the cord be 15 amperes (minimum) and 120 volts.

Consumer Support Troubleshooting Tips

2

Safety Instructions

HOW TO CONNECT ELECTRICITY

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this appliance must be properly grounded.

The power cord of this appliance is equipped with
a 3-prong (grounding) plug which mates with
a standard 3-prong (grounding) wall outlet to
minimize the possibility of electric shock hazard
from this appliance.

Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
properly grounded.

If you have only a standard 2-prong wall outlet,
it is your personal responsibility and obligation to
have it replaced with a properly grounded
3-prong wall outlet.

The wine chiller should always be plugged into its
own individual electrical outlet which has
a voltage rating that matches the rating plate.

This provides the best performance and also
prevents overloading house wiring circuits which
could cause a fire hazard from overheated wires.

Never unplug your wine chiller by pulling on
the power cord. Always grip plug firmly and
pull straight out from the outlet.

Repair or replace immediately all power cords
that have become frayed or otherwise damaged.
Do not use a cord that shows cracks or abrasion
damage along its length or at either end.

When moving the wine chiller away from the wall,
be careful not to roll over or damage the power
cord.

USE OF ADAPTER PLUGS

Adapter plugs are not permitted in Canada.

Instructions

Installation

Instructions

Operating

Care and Cleaning

READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.

SAVE THESE INSTRUCTIONS

Consumer SupportTroubleshooting Tips

3

Installing the wine chiller.

Removing the Packaging

Before using the wine chiller, be sure all packing materials and tape have been
removed, including any protective film covering the control and any film protecting
the cabinet.

Safety Instructions

If you are discarding an old refrigeration product, remove the doors to reduce the
danger of children being trapped inside.

Installation Guidelines

Installation

Instructions

Operating

Instructions

Care and Cleaning

To raise the wine chiller

The wine chiller must be freestanding.

Allow the following clearances for ease

of installation, proper air circulation and
electrical connections:

Each side 2" (51 mm)
Top 2" (51 mm)
Back 3" (51 mm)

Before connecting the appliance to the

power source, let it stand upright for
approximately 2 hours. This will reduce
the possibility of a malfunction in the
cooling system from handling during
transporation.

Leveling Legs

Adjustable legs at the front corners of the

wine chiller should be set so the wine chiller
is firmly positioned on the floor, with a 1/8"
(3 mm) tilt to the back to help the door
closure.

To adjust the leveling legs, turn the
legs clockwise to raise the wine chiller,
counterclockwise to lower it.

Do not install the wine chiller where the

temperature will go below 55°F (13°C) or
above 90°F (32°C).

Install it on a level floor.

Do not install the wine chiller where it

will be subject to direct sunlight, heat or
moisture.

Do not store or install this appliance

outdoors.

Loading the Wine

As with any refrigeration product, there is a slight temperature variance at different
locations within the cabinet. In this wine chiller, the lower shelves provide a slightly cooler
temperature than the upper shelves.

When storing both red and white wines, it is best to store the white wine on the lower
shelves where the temperature is slightly cooler.

Consumer Support Troubleshooting Tips

4

About the controls and settings.

Setting the Temperature Control

Display Panel

You can set the temperature as you desire

by pushing the button
(Down). When you push the two buttons for
the first time, the LED readout will show the
original temperature set at the factory (the
temperature preset at the factory is 50ºF/10°C).

Temperature Display Panel (Wine Types)

(Up) or

The temperature that you desire to set will

increase 1ºF (0.5°C) if you push the
The temperature will decrease 1ºF (0.5°C) if you

push the

once.

once.

Safety Instructions

Instructions

Installation

When the Wine Chiller is Plugged In

After plugging in the wine chiller and making your
temperature selection, allow the wine chiller to
reach the set temperature before loading your
wine. This may take up to 12 hours to completely
stabilize.

Power Button

The Power button turns the cooling system off.

Lock/Unlock Key Button

Pressing the lock/unlock key, 1 min later the

keyboard will be locked not including the
key.

Interior Light

SPARKL: 41-45°F (5-7°C)
WHITE: 46-54°F (8-12°C)
RED: 55-65°F (13-18°C)

After loading the wine, you may notice a rise
in the temperature. Allow adequate time for
the temperature to return back to the set
temperature. This may take up to 12 hours to
completely stabilize.

There are 2 short "ding" sounds when locked.

Press
one second long "ding" when unlocked.

for one second to unlock. There is a

Instructions

Operating

Care and Cleaning

You can turn the interior light on or off by pushing the button.

Important:

Initially, the temperature defaults to 50°F (10°C)

factory setting. When it restarts (ie. after a
power failure), it will default back to factory
the factory setting.

In order to extend the compressor life, please

restart wine cooler after waiting 3 minutes.

Malfunction indicators:

Sensor problem show E1;
Self diagnostic error show E3;
Communication problem show E4;
Too cold in cabinet show L.

In this condition, a buzzer will hum for one second
every 30 seconds.

Call for service if any of the above error messages
show.

You should touch the temperature control panel
softly as the panel is touch screen control. Please
protect the touch control panel carefully to avoid
scratching,keep far away from strong magnetic
fields and high humidity, or it can cause wine
cooler to not work properly.

5

Consumer SupportTroubleshooting Tips