Moffat MGH701 INSTRUCTION BOOK

GB
GAS HOB
MGH 701
Please read this instruction booklet before using the appliance
Important Safety Information
You MUST read hese warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 950950
z This appliance must be installed and serviced by a
competent person as stated in the Gas Safety (Installation and Use) Regulations Current Editions and the IEE Wiring Regulations.
z Remove all packaging before using the hob. z Ensure that the gas and electrical supply complies
with the type stated on the rating plate, located near the gas supply pipe.
z Do not attempt to modify the hob in any way .
Child Safety
z This hob is designed to be operated by adults. Do
not allow children to play near or with the hob.
z This appliance is not intended for use by children or
other persons whose physical, sensory or mental capabilities or lack of experience and knowledge prevents them from using the appliance safely without supervision or instruction by a responsible person to ensure that they can use the appliance safely .
z The hob gets hot when it is in use. z Children should be kept away until it has cooled. z Children can also injure themselves by pulling pans
or pots off the hob.
During Use
z This hob is intended for domestic cooking only . It is
not designed for commercial or industrial purposes.
z This appliance is not connected to a combustion
products evacuation device. It must be installed and connected in accordance with current installation regulations. Particular attention shall be given to the relevant requirements regarding ventilation.
z When in use a gas cooking appliance will produce
heat and moisture in the room in which it has been installed. Ensure there is a continuous air supply, keeping air vents in good condition or installing a cooker hood with a venting hose.
z When using the hob for a long period time, the
ventilation should be improved, by opening a window or increasing the extractor speed.
z Do not use this hob if it is in contact with water .
Do not operate the hob with wet hands.
z Ensure the control knobs are in the ‘OFF’ position
when not in use.
z When using other electrical appliances, ensure the
cable does not come into contact with the hot surfaces of the cooking appliance.
z Unstable or misshapen pans should not be used on
the hob as unstable pans can cause an accident by tipping or spillage.
2
z Never leave the hob unattended when cooking with
oil and fats.
z Never use plastic or aluminium foil dishes on the hob. z Perishable food, plastic items and areosols may be
affected by heat and should not be stored above or below the hob unit.
Service
z This hob should only be repaired or serviced by an
authorised Service Engineer and only genuine approved spare parts should be used.
Environmental Information
z After installation, please dispose of the packaging
with due regard to safety and the environment.
z When disposing of an old appliance, make it unusable,
by cutting off the cable.
z The symbol on the product or on its packaging
indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
Guide to Use the instructions
The following symbols will be found in the text to guide you throughout the Instructions:
Safety Instructions
Step by step instructions for an operation
))
)
))
Hints and Tip s
Environmental Information
Keep this instruction book for future reference
and ensure it is passed on to any new owner.
Content s
For the User
Important Safety Information 2 Description of the Hob 3 Operation 4 Maintenance and Cleaning 4 Something Not Working? 5 Service and Spare Parts 14 Guarantee Conditions 14 European Guarantee 14
For the Installer
Instructions for the Installer 6 Important safety requirements 7 Installation 8 Building In 9 Electrical connections 10 Wiring Diagram 11 Fault Finding 1 1 Commissioning 13 Conversion from Natural Gas to LPG 13
Description of the Hob
1. Auxiliary Burner
1
3
2
4
2
5
2. Semi-rapid Burners
3. Rapid Burner
4. Triple crown Burner
5. Control knobs
3
Operation
Hob burners
T o light a burner:
))
)
))
z push in the relevant control knob and turn it
anticlockwise to maximum position;
z then adjust the flame as required.
If the burner does not ignite, turn the control knob to zero, and try again.
To ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used (see table). Burner minimum maximum
If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat.
T ake care when frying food in hot oil or fat, as the overheated splashes could easily ignite.
As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering.
If the control knobs become difficult to turn, please contact your local Service Force Centre.
diameter diameter
Triple crown 180 mm. 260 mm. Large (rapid) 180 mm. 260 mm. Medium (semi-rapid) 120 mm. 220 mm. Small (auxiliary) 80 mm. 160 mm.
Using the Wok Stand
A wok stand is provided to enable you to use a round bottomed wok on the hob. The wok stand must only be used on the central burner, and should not be used with any other type of wok or pan.
When fitting the wok stand, ensure the recesses in the frame fit securely onto the bars of the pan supports, as shown in the diagram.
Maintenance and Cleaning
The Hob To p
Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little washing up liquid has been added. Avoid the use of the following:
- household detergent and bleaches;
- impregnated pads unsuitable for non-stick saucepans;
- steel wool pads;
- bath/sink stain removers. Should the hob top become heavily soiled, it is recommended that a cleaning product such as Hob Brite or Bar Keepers Friend is used.
Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply .
The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool.
Pan Support s and W ok Stand
The pan supports and the Wok Stand are dishwasher proof. If washing them by hand, take care when drying them as the enamelling process occasionally leaves rough edges. If necessay, remove stubborn stains using a paste cleaner.
4
The Burners
The burner caps and crowns can be removed for cleaning. Wash the burner caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove. After cleaning, be sure to wipe dry with a soft cloth.
Ignition candle
The electric ignition is obtained through a ceramic "candle" and a metal electrode. Keep these components well clean, to avoid difficult lighting, and check that the burner crown holes are not obstructed.
Something Not Working?
If the hob is not working correctly , please carry out the following checks before contacting your local Service Force Centre.
SYMPTOM
There is no spark when lighting the gas
The gas ring burns unevenly
If after all these checks, your hob still does not operate correctly , contact your local Service Force Centre.
Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.
SOLUTION
Check that the unit is plugged in and the electrical
supply is switched on
Check that the RCCB has not tripped (if fitted)Check the mains fuse has not blownCheck the burner cap and crown have been
replaced correctly , e.g. after cleaning.
Check the main jet is not blocked and the burner
crown is clear of food particles.
Check the burner cap and crown have been
replaced correctly , e.g. after cleaning.
In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.
5
Loading...
+ 11 hidden pages