Moen YB5408WR Specs

25300 AL MOEN D RI VE  NOR TH OLMSTED , OH 44070
COR PORATE H EADQU ARTERS: [phone]  F AX: [phone]
IN TER NATION AL: [phone]  FAX: [phone]
CU STOMER SERVI CE (USA): 800 -882-0116  FAX: [phone]
WW W. MOEN .C OM

Copyright Creative Specialties International

Paper Holder is constructed of zinc.

 YB5408AN – Paper Holder

Antique Nickel Finish

 YB5408AZ – Paper Holder

Antique Bronze Finish

 YB5408BN – Paper Holder

Brushed Nickel Finish

 YB5408CH – Paper Holder

Chrome Finish

 YB5408ORB – Paper Holder

Oil Rubbed Bronze Finish

 YB5408PB – Paper Holder

Polished Brass Finish

 YB5408WR – Paper Holder

Wrought Iron Finish

Cleaning Instructions:

Stock Number:______________________Paper Holder

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Paper Holder

YB5408

Kingsley® Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Literature #BA1118

1. Position the mounting template on the wall in the desired location.
Using a level, align the template and tape it to the wall.

2. Remove each mounting post from the body by loosening the set screw.

3. Place each mounting post on the template with notch facing down.

4. Mark the 2 large hole locations of each mounting bracket.

5. Attach each mounting bracket to the wall, using the wall anchors
provided.

6. Mount each base on the corresponding mounting bracket. Check and
make sure that the base set screw hole(s) are facing down. Assemble a
set screw to each base. Use the allen wrench included in hardware kit
to tighten each set screw and secure the assembly to the mounting
bracket(s).

7. Tighten all 4 screws. Do not over tighten.

8. Place each post over the mounting plate (set screw down). Pivoting

post with bar to be on left side. Tighten both set screws.