Moen YB0824CH, YB0818CH Specs

25300 AL MO EN DRIVE  NORTH OLMS T E D , O H 44070
CORPORATE HEA D Q U A R T E R S : [phone]  FAX: [phone]
INTERNATIONA L: [phone]  FAX: [phone]
CUSTOMER SERV ICE (USA): 800-882-0116  FAX: [phone]
WWW.MOEN.COM

Copyright Creative Specialties International Literature #BA1719

Towel bar posts are constructed of
zinc. Bar is constructed of brass.

 YB0818BN – 18” Towel Bar

Brushed Nickel Finish

 YB0818CH – 18” Towel Bar

Chrome Finish

 YB0824BN – 24” Towel Bar

Brushed Nickel Finish

 YB0824CH – 24” Towel Bar

Chrome Finish

Cleaning Instructions:

Stock Number:______________________Towel Bar

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

18” & 24” Towel Bar

YB0818 & YB0824

ArrisTM Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

1) Position the mounting template on the wall in the desired location.

2) Using a level, align the template and tape it to the wall.

3) Drill two ¼” holes at each mounting post location that corresponds to
your product.

4) Remove the template from the wall.

5) Disassemble screws and washers from anchors.

6) Lightly tap anchors until flush with the wall.

7) Remove mounting posts from the product assemblies by loosening
each setscrew.

8) One at a time, place each mounting plate over anchors (with “UP”
facing you) and insert screw and washer through plate into anchor.

9) Tighten screws until anchor is activated behind wall (approximately
45 turns) and tight.

10) Position each end post with setscrews facing down and place over
both mounting posts. Tighten the setscrew at the bottom of each
post.