Moen YB0803CH Specs

25300 AL MO EN DRIVE  NORTH OLMS T E D , O H 44070
CORPORATE HEA D Q U A R T E R S : [phone]  FAX: [phone]
INTERNATIONA L: [phone]  FAX: [phone]
CUSTOMER SERV ICE (USA): 800-882-0116  FAX: [phone]
WWW.MOEN.COM

Copyright Creative Specialties International Literature #BA1717

Robe Hook is constructed of zinc.

 YB0803BN – Robe Hook

Brushed Nickel Finish

 YB0803CH – Robe Hook

Chrome Finish

Cleaning Instructions:

Stock Number:______________________Robe Hook

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Robe Hook

YB0803

ArrisTM Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

1. Remove mounting plate from the product post by loosening each setscrew

2. Position the mounting plate on the wall at desired location with “UP” facing
you. Mark hole locations.

3. Drill 2 holes as marked using 5/16” drill bit.

4. Fold ends of the plastic toggle anchor together and insert into each hole in
the wall.

5. Lightly tap anchors until flush with the wall.

6. One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor. Removepin and repeat on other anchor.

7. Place the mounting plate on the wall over the installed wall anchors with "UP"
facing you.

8. Tighten screws.

9. Place decorative product over the mounting plate with setscrew facing down

and tighten setscrew.