Moen YB0402BN Specs

 YB0402CH – Swiveling Double Robe

Hook

Chrome Finish

 YB0402BN – Swiveling Double Robe

Hook

Brushed Nickel Finish

25300 AL MO EN DRIVE  NORTH OLMS T E D , O H 44070
CORPORATE HEA D Q U A R T E R S : (800) 321 - 8809  FAX: [phone]
INTERNATIONA L: [phone]  FAX: [phone]
CUSTOMER SERV ICE (USA): 800-882-0116  FAX: [phone]
WWW.MOEN.COM

Copyright Creative Specialties International Literature # BA1218

Swiveling Double Robe Hook is
constructed of zinc.

Cleaning Instructions:

Stock Number: YB0402 Swiveling Double Robe Hook

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Swiveling Double Robe Hook

YB0402

ALIGN™ Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Tools Required: Phillips screwdriver, drill, 1/4” drill bit, hammer, level, tape
Hardware Kit Contents: 2 anchors, 1 hex wrench
Note: Directions below are for installation into drywall. If installing product
into a stud, use the wood screws only.

1) Remove mounting posts from the product assemblies by loosening each
setscrew.

2) Position the mounting plate on the wall in the desired location and mark
holes at the Horizontal screw location on the template if installing into
drywall or vertical screw location if installing into a stud.

3) Drill 1/4” pilot holes in marked locations.

4) Lightly tap anchors until flush with the wall.

5) Place each mounting plate over anchors and insert screws through post
into anchors.

6) Tighten screws.

7) Place posts over the mounting plates with setscrew facing down and
tighten setscrew.