Moen MT531C User Manual

Slip Fit Spouts

WITH THE "O"-RING SEAL

Lookout must be free from deep scratches, dents, kinks or bends. The cut-off end must be free from burrs inside and out. The edge must not be rolled inward from a dull tubing cutter.

The spouts are specifically designed to permit the

use of copper water tube on drops and lookouts.

FINISHED

WALL LINE

1/2" COPPER WATER TUBE

MT531C MAY 02

Turn spout upright into position against the wall and finish tightening the clamp screw by hand. The use of pliers or another wrench on the hex wrench is not necessary. Do not overtighten.

CLAMP SCREW

Press and twist the spout onto the lookout upside down. Tighten the clamp screw with a 5/32" hex wrench until it just starts to bind.

MT531C

LOOKOUT LENGTH

(ROUND BASE SPOUT SHOWN)

1-1/2" MIN.

3" MAX.