Moen MT036C User Manual



FLOW

RESTRICTOR

FLAT

GASKET

➤

CAUTION: do not use flat gasket

when flow restrictor is used ---

flow restrictor serves as gasket.

MT036C

HAND-HELD PULSATION SHOWERS

INST ALLA TION INSTRUCTIONS

MODEL 3980

Hand-held Pulsation head and gasket only.

MODEL 3989

Hand-held Pulsation head, double spiral hose

with gaskets, two swivel wall brackets

and vacuum breaker

MODEL 3992 OR 52710

Hand-held Pulsation head,

double spiral hose with gaskets

vacuum breaker and 30" slide bar.

THIS BAR IS

NOT

USE FOR SUPPORT.

A GRAB BAR.

MODEL 3991

Consists of all parts in Model 3989, plus a

shower arm diverter. Install it between the

shower arm and showerhead.

Hand-held Pulsation head, white vinyl hose,

MODEL 3985

shower arm diverter, vacuum breaker, and

showerhead holder.

CAUTION: Do not connect hand-held shower unit directly to the tub drop in a tub shower installation, excessive back pressure will result in shared water between the hand-held unit and the showerhead.

See Installation instructions

continued on following page.

TO INSTALL WALL BRACKETS:

91869 ADHESIVE PAD

➤

Models using wall brackets are furnished with two. One is used to mount the Pulsation head in a fixed position for a standing shower. The other can be used as a holder above the tub, within easy reach for a seated shower. The standard distance above the floor for the upper bracket is six feet; however, this can be varied to suit the comfort of the user. Mount the lower one within easy reach from a sitting position in the tub and high enough to clear the rim. Mark the screw hole positions and drill 1/4" holes to fit the screw anchors furnished.

Vacuum Breaker must be installed more than 2" above rim of tub.

TO INSTALL SLIDE BAR:

Mount vertically with the lower end 54" above the floor, or in a position to suit the comfort of the user. Mark the screw hole positions and drill 1/4" holes to fit the screw anchors furnished. THIS BAR IS

NOT

A GRAB BAR. DO

NOT

USE FOR SUPPORT.

TO INSTALL PULSATION SHOWERHEAD HOLDER:

Remove the showerhead. If the installation is on a flat wall, remove the shower arm flange. On walls offset by tile, leave the flange on the arm. Use plumbers putty in the cavity around the shower arm. Apply the two-sided adhesive pad to the back of the holder, either side up, just above the opening. Remove outer protective paper. Press and work the holder over the shower arm. This is an interference fit on the arm and it is a tight fit over the thread. Press it against the wall to seal. Install diverter and showerhead as shown. Tighten all joints. Trim edges of adhesive pad.

STATIONARY

SHOWERHEAD

NOT FURNISHED

MT036C APR 98

BACK VIEW

OF SHOWERHEAD

HOLDER

HELPLINE: Call our toll free Helpline number,

(800) 289-6636;

for answers to any product, installation, replacement parts, or warranty questions.



25300 Al Moen Drive, North Olmsted, OH 44070

Printed in U.S.A.