Moen MOE9127 Specifications

Beleld™ Accessories Technical Specication

m

Paper Holder YB6408

Stock Numbers: Dimensions:

YB6408CH – Paper Holder

Chrome

YB6408BN – Paper Holder

Brushed Nickel

YB6408ORB – Paper Holder

Oil Rubbed Bronze

6.25"

159mm

4.24"

108mm

1.79"

45mm

120m

81mm

4.74"

3.2"

Materials:

Paper Holder is constructed of zinc.

Installation Instructions:

Directions below are for installation into drywall. If installing product into a stud,

use the wood screws only.

1. Position the mounting template on the wall in the desired location.

2. Using a level, align the template and tape it to the wall.

3. Drill two 5/16" holes as indicated on the template

4. Remove the template from the wall

5. Fold ends of the plastic toggle together and insert into each hole in the wall.

6. Lightly tap anchors until ush with the wall.

7. One at a time, insert plastic in into each of the anchors and lightly tap to
activate anchor. Remove pin and repeat on all anchors.

8. Remove mounting posts from the product assemblies by loosening each set
screw.

9. Place the mounting plate on the wall over the installed wall anchors with
“UP” facing you.

10.

Insert screws through the mounting plate into the anchors. Tighten the screws.

11. Place each assembly over the mounting posts with the set screws facing
down. Pivoting posts with bar should be on the left side. Tighten both set
screws

Cleaning Instructions:

To preserve the ne nish of this product, clean only with a soft damp

cloth. Dry well. Do not use commercial or abrasive cleaners.

Stock Number: _____________________ Paper Holder
By Moen Incorporated

25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©Copyright Moen Incorporated