Page 1
Glyde™ Accessories Technical Specication
(45mm)
(81mm)
Robe Hook YB2303
Stock Numbers:
YB2303BN – Robe Hook
Brushed Nickel Finish
YB2303CH – Robe Hook
Chrome Finish
Materials:
Dimensions:
3-5/16"
(83mm)
1-3/4"
Installation Instructions:
3-3/16"
Robe Hook is constructed of zinc.
Directions below are for installation into drywall. If installing product into a
stud, use the wood screws only.
1. Using ¼" drill bit, drill one pilot hole for post.
2. Position mounting post to wall by inserting wall anchor into pilot hole
and pressing rmly.
3. Make sure that locking tab on mounting post is facing down.
4. Tighten wall anchor screw while holding mounting post rmly in
place. Tighten anchor until resistance increases. DO NOT over
tighten.
5. Using tip of screw bit press wall spikes (metal pieces on outer edge
of mounting post) into drywall.
6. Attach post by pressing rmly to mounting post until it clicks. (The
square opening at the base of the post must be facing down to
match-up with locking tab).
Cleaning Instructions:
To preserve the ne nish of this product, clean only with a soft damp
cloth. Dry well. Do not use commercial or abrasive cleaners.
Stock Number: _______________________ Robe Hook
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321-8809 • FAX: (800) 848-6636
INTERNATIONAL: (440 ) 962-2000 • FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: (888) 379-2720
WWW.MOEN.COM
©
Copyright Moen Incorporated
Loading...