Moen MOE8965 Specifications

Genta™ Technical Specication

Paper Holder

Stock Numbers:

☐ BH3808CH – Paper Holder
Chrome Finish

Dimensions:

3-1/4"
83mm

BH3808

7-53/64"
199mm

6-1/16"
154mm

Materials:

Paper Holder is constructed of zinc.

Installation Instructions:

1. Remove the mounting bracket from the body by loosening the setscrew.

2. Position the assembled unit on the wall where desired.

3. Lightly mark the outline of each base.

4. Center a mounting bracket within each base outline with “UP” facing you.

5. Mark the 2 large hole locations of each mounting bracket.

6. Attach each mounting bracket to the wall, using the wall anchors provided

7. Mount each base on the corresponding mounting bracket. Check and make
sure that the base set screw hole(s) are facing down. Assemble a set screw
to each base. Use the allen wrench included in hardware kit to tighten each
set screw and secure the assembly to the mounting bracket(s).

Installation Instructions:

To preserve the ne nish of this product, clean only with a soft

damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Stock Number: Paper Holder

By MOEN

25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: [phone] • FAX: [phone]
CUSTOMER SERVICE (USA): [phone] • FAX: [phone]
WWW.MOEN.COM

©

Copyright Moen, Inc.