Page 1
Edgestone™ Accessories Technical Specication
(138mm)
2-3/8"
(176mm)
Paper Holder YB4609
Stock Numbers:
YB4609BN – Paper Holder
Brushed Nickel Finish
YB4609CH – Paper Holder
Chrome Finish
Materials:
Dimensions:
(60mm)
5-7/16"
Installation Instructions:
1-1/2"
(37mm)
7"
Paper Holder is constructed of zinc and
steel.
This product features the Pro+Fit Installation Mounting System. If you do not
have the Pro+Fit Installation Template please use the following instructions.
(Note: only one hole is required per mounting post.)
1. Mark on the wall where you want to install the product.
2. Using ¼" drill bit, drill one pilot hole for the post.
3. Position mounting post to wall by inserting wall anchor into pilot hole and
pressing rmly.
4. Make sure that locking tab on mounting post is facing down (6 o’clock).
5. Tighten wall anchor screw while holding mounting post rmly in place. DO
NOT over tighten (6 – 8 full turns will secure the anchor).
6. Attach post by pressing rmly to mounting post until it clicks. (The square
opening at the base of the post must be facing down to match-up with
locking tab.)
If you are mounting any parts into a hard surface snap off the anti-rotation ns on
the back of the mounting post.
Cleaning Instructions:
To preserve the ne nish of this product, clean only with a soft damp cloth. Dry
well. Do not use commercial or abrasive cleaners.
Stock Number: _____________________ Paper Holder
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321-8809 • FAX: (800) 848-6636
INTERNATIONAL: (440 ) 962-2000 • FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: (888) 379-2720
WWW.MOEN.COM
©
Copyright Moen Incorporated
Loading...