Moen DN7065 User Manual

Tool-Free Transfer Bench is made of

ABS Plastic, Aluminum, EPDM, and
Stainless.

WARNING

TO PREVENT SERIOUS OR FATAL INJURY:
Insure product is assembled, adjusted and used
properly. FOR USE ONLY BY PERSONS
WEIGHING LESS THAN 250 POUNDS. Failure
to follow correct assembly and/or adjustment
procedures can make the seat unstable. ALL
FOUR LEGS MUST BE LOCKED IN PLACE AT
THE SAME HEIGHT. DO NOT jump on, stand on
or tilt. Contact CSI immediately at 1-800-882­0116 if any components are missing or damaged.
Do not modify or substitute any components.
FOR QUESTIONS OR ASSISTANCE WITH
ASSEMBLY CONTACT CSI AT 1-800-882-0116.
Consult healthcare professional for advice and
in structions spe cific to user’s needs before use.

 DN7065 – Tool-Free Transfer

Bench

White

1. Determine orientation of chair relative to w ater supply in order for transfer bench to
be positioned outside of bathtub.

2. Locate the two under seat support beams: Hold the pieces by the straight end with
the curved end away from you.

3. Locate the flat, indented area of each beam: Place the two flat areas together, so
they are touching, and the tw o beams form an "X" shape.

4. Locate the leg unit w ith top posts that point inward: Align the posts with the straight
ends of the crossed support beams on the small end of the "X".

5. Slide the top posts of the leg unit over the ends of the crossed support beams.

6. Take the remaining leg unit, w ith the top posts that point straight out, and align it
with the curved end of the support beams, at the large side of the "X".

7. Slide the top posts of the leg unit over the ends of the crossed support beams.

8. Locate the transfer bench. Place it seat side down.

9. Place the curved ends of the crossed support beams into the grooves on the
underside of the transfer bench, aligning the holes in the support beams with the
holes inside the grooves.

10. Use the assembly knobs to attach the transfer bench to the support beams.
Thread the w ashers onto the bolt, small lock washer first, follow ed by the cup
washer.

11. Locate the large seat bottom. Place it under the support beams so that the center

12. of the "X" slides into the center of the "X" shaped grooves on the large seat
bottom.

Stock Number:_________________ TF Transfer Bench
By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Tool Free Transfer Bench

DN7065

Home Care Technical Specification

25300 AL MOEN D R IVE  N OR TH OLMSTED , OH 44070
CORPORATE H EADQUARTER S: [phone]  F AX: [phone]
INTER NATI ON AL: (440) 962 -2000  FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116  FAX: [phone]
WWW.MOEN.C OM

Copyright Creative Specialties International

Literature #BA1370