Moen CSI2225 Specifications

 DN7918BN – 18” Towel Bar
Brushed Nickel Finish
DN7924BN – 24” Towel Bar
Brushed Nickel Finish
DN7918BRB – 18” Towel Bar
Mediterranean Bronze Finish
DN7924BRB – 24” Towel Bar
Mediterranean Bronze Finish
DN7918CH – 18” Towel Bar
Chrome Finish
DN7924CH – 24” Towel Bar
Chrome Finish
Copyright Creative Specialties International Literature # BA1587
Towel Bar post is die cast from highest quality zinc alloy (Zamac). Casting is plated Chrome, Brushed Nickel or Mediterranean Bronze. Towel bar is aluminum for Brushed Nickel and Chrome finishes and stainless steel for Mediterranean Bronze.
Cleaning Instructions:
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16” holes at each mounting post location that corresponds to your product.
4. Remove the template from the wall.
5. Fold ends of the plastic toggle together and insert into each hole in the wall.
6. Lightly tap anchors until flush with the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to activate anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each setscrew.
9. Place the mounting plate on the wall over the installed wall anchors with “UP” facing you.
10. Insert screws through the mounting plate into the anchors. Tighten the screws.
11. Assemble the towel bar and posts.
12. While assembled, position each end post with setscrews facing down and place over both mounting posts. Tighten the setscrews.
Stock Number:______________________Towel Bars By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bars
DN7918 & DN7924
Ashville Technical Specification
To preserve the fine finish of this product, clean only with a soft damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Loading...