
1. Position the mounting template on th
e wall in the desired location. Using a
______________________Towel Bar
Preston Technical Specification
Stock Numbers:
q
Polished Brass Finish
Concealed Screw Mounting
¾” Round Bar
q DN8418CH – 18” Towel Bar
Polished Chrome Finish
Concealed Screw Mounting
¾” Round Bar
q DN8418MPW – 18” Towel Bar
Matte Pewter Finish
Concealed Screw Mounting
¾” Round Bar
q DN8418BN – 18” Towel Bar
Brushed Nickel Finish
Concealed Screw Mounting
¾” Round Bar
q DN8424PB – 24” Towel Bar
Polished Brass Finish
Concealed Screw Mounting
¾” Round Bar
q DN8424CH – 24” Towel Bar
Polished Chrome Finish
Concealed Screw Mounting
¾” Round Bar
q DN8424MPW – 24” Towel Bar
Matte Pewter Finish
Concealed Screw Mounting
¾” Round Bar
q DN8424BN – 24” Towel Bar
Brushed Nickel Finish
Concealed Screw Mounting
¾” Round Bar
level, align the template and tape it to the wall.
2. Place each mounting plate on the template with “UP” facing you.
3. One at a time, place each anchor screw through the mounting plate,
centered in each large hole. Using a Phillips screwdriver, turn the anchor
screw while applying pressure. Screw will self drill and tap into drywall.
Do not over tighten.
4. Only insert screw ½ to ¾ of the way into wall.
5. After all screws are installed, tear the template away from the wall
6. Tighten all 4 screws. Do not over tighten.
7. Assemble the towel bar and posts.
8. While assembled, position each end post with the setscrew down and place
over both mounting plates. Tighten the setscrew at the bottom of each base.
highest quality zinc alloy (zamac).
Rod is aluminum. Castings are triple
plated with a polished brass, polished
chrome, or matte pewter finish.
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
By CSI Bath Furnishings
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070 (800) 321 -8809 •
FAX: (800) 848-6636 • INTERNATIONAL: (440) 962-2000 •
Copyright CSI Bath Furnishing Division of Moen 02/22/01
Literature #BA1047