1. Drawer pulls will require 3/16” holes.
2. The distance between holes is 3” on center.
3. Using a level, mark the location of the two holes.
4. Use a 3/16” drill bit to drill two holes.
5. Insert the screws into each hole.
6. Place the drawer pull over the screws.
7. Use a Phillips screwdriver to tighten screws.
25300 AL MOEN DRI VE NORTH OLMSTED, OH 44070
CORPORATE H EADQUARTER S: (800) 321-8809 F AX: (800) 848-6636
INTERNATI ON AL: (440) 962-2000 FAX: (440) 962-2726
CUSTOMER SERVICE (U SA): 800 -882-0116 F AX: (888) 379 -2720
WWW .MOEN. COM
Copyright Creative Specialties International Literature #BA1562
Drawer Pulls are constructed of zinc.
YB8207BN – Drawer Pull
Brushed Nickel Finish
YB8207CH – Drawer Pull
Chrome Finish
YB8207ORB – Drawer Pull
Oil Rubbed Bronze Finish
Cleaning Instructions:
Stock Number:______________________Drawer Pull
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Drawer Pull
YB8207
Rothbury™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Loading...