Moen CSI1713 Specifications

 DN9103BN – Robe Hook

Brushed Nickel Finish

 DN9103BRB – Robe Hook

Mediterranean Bronze Finish

 DN9103CH – Robe Hook

Chrome Finish

25300 AL MOEN D RI VE  NOR TH OLMSTED , OH 44070
COR PORATE H EADQU ARTERS: [phone]  FAX: [phone]
IN TER NATION AL: [phone]  FAX: [phone]
CU STOMER SERVI CE (USA): 800 -882-0116  FAX: [phone]
WWW.MOEN .C OM

Copyright Creative Specialties International Literature # BA1589

Robe Hook post is die cast from
highest quality zinc alloy (Zamac).

Cleaning Instructions:

1. Remove mounting posts from the product assemblies by
loosening each setscrew.

2. Position the mounting plate on the wall at desired location with
“UP” facing you. Mark hole locations.

3. Drill 2 holes as marked using 5/16” drill bit.

4. Fold ends of the plastic toggle anchor together and insert into
each hole in the wall.

5. Lightly tap anchors until flush with the wall.

6. One at a time, insert plastic pin into each anchor and lightly tap to
activate anchor. Remove pin and repeat on other anchor.

7. Place the mounting plate on the wall over the installed wall
anchors with “UP” facing you.

8. Tighten screws.

9. Place decorative product over the mounting plate with the
setscrew facing down. Tighten setscrew.

Stock Number:______________________Robe Hook
By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Robe Hook

DN9103

Ellsworth Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.