DN7908BN – Pivoting Paper
Holder
Brushed Nickel Finish
DN7908BRB – Pivoting
Paper Holder
Mediterranean Bronze Finish
DN7908CH – Pivoting Paper
Holder
Chrome Finish
25300 AL MOEN D RIVE NOR TH OLMSTED , OH 44070
COR POR ATE H EADQUAR TER S: (800) 321 -8809 F AX: (800) 848 -6636
IN TER N ATI ONAL: (440) 962-2000 FAX: (440) 962-2726
CU STOMER SERVI CE (U SA): 800 -882-0116 F AX: (888) 379-2720
WWW.MOEN.C OM
Copyright Creative Specialties International Literature # BA1586
Pivoting Paper Holder post is die
cast from highest quality zinc alloy
(Zamac). Casting is plated Chrome,
Brushed Nickel or Mediterranean
Bronze. The Pivoting Paper Holder
arm is stainless steel.
Cleaning Instructions:
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16” holes at each mounting post location that
corresponds to your product.
4. Remove the template from the wall.
5. Fold ends of the plastic toggle together and insert into each hole
in the wall.
6. Lightly tap anchors until flush with the wall.
7. One at a time, insert plastic pin into each of the anchors and
lightly tap to activate anchor. Remove pin and repeat on all
anchors.
8. Remove mounting posts from the product assemblies by
loosening each setscrew.
9. Place the mounting plate on the wall over the installed wall
anchors with “UP” facing you.
10. Insert screws through the mounting plate into the anchors.
Tighten the screws.
11. Place each assembly over the mounting posts with setscrews
facing down. Pivoting post with bar should be on the left side.
Tighten both setscrews.
Stock Number:______________________Pivoting
Paper Holder By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Pivoting Paper Holder
DN7908
Ashville™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Loading...