25300 AL MOEN D RI VE NOR TH OLMSTED , OH 44070
COR PORATE H EADQU ARTERS: (800) 321-8809 FAX: (800) 848-6636
IN TER NATION AL: (440) 962-2000 FAX: (440) 962-2726
CU STOMER SERVI CE (USA): 800 -882-0116 FAX: (888) 379-2720
WW W. MOEN .C OM
Copyright Creative Specialties International
Directions below are for installation into drywall. If installing product into a
stud, use the wood screws and washers provided only.
1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the w all.
3. Drill tw o 5/16” holes as indicated on the template.
4. Remove the template from the wall.
5. Fold the ends of the plastic toggle together and insert into each hole in the
wall.
6. Lightly tap anchors until flush with the w all.
7. One at a time, insert plastic pin into each of the anchors and lightly tap into
activate anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each
setscrew .
9. Place the mounting plate on the w all over the installed w all anchors w ith “UP”
facing you.
10. Insert screw s through the mounting plate into the anchors. Tighten the
screws.
11. Assemble the towel bar and posts
12. While assembled, position each end post w ith setscrews facing down and
place over both mounting posts. Tighten the setscrew at the bottom of each
post.
Towel Bar posts are constructed of
zinc. Bar is aluminum.
DN0718CH – 18” Towel Bar
Chrome Finish
DN0718BN – 18” Towel Bar
Brushed Nickel Finish
DN0724CH – 24” Towel Bar
Chrome Finish
DN0724BN – 24” Towel Bar
Brushed Nickel Finish
Cleaning Instructions:
Stock Number:______________________Towel Bar
By Creative Specialties
Materials:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN0718 & DN0724
Iso™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1400
Installation Instructions:
Loading...