Moen CSI1361 Specifications

Towel Bar post is die cast from the

highest quality zinc alloy (Zamac).
Casting is plated in chrome, brushed
nickel or oil rubbed bronze. Towel
bar is aluminum for brushed nickel
and chrome finishes and brass for oil
rubbed bronze.

 DN3618BN – 18” Towel Bar

Brushed Nickel Finish

 DN3624BN – 24” Towel Bar

Brushed Nickel Finish

 DN3618CH – 18” Towel Bar

Chrome Finish

 DN3624CH – 24” Towel Bar

Chrome Finish

 DN3618ORB – 18” Towel Bar

Oil Rubbed Bronze Finish

 DN3624ORB – 24” Towel Bar

Oil Rubbed Bronze Finish

Cleaning Instructions:

Stock Number:_____________________18” & 24” Towel Bar

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

18” & 24” Towel Bar

DN3618 & DN3624

Bradshaw™ Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

25300 AL MOEN DRIVE  NORTH OLMSTED, OH 44070
COR POR ATE HEAD QUAR TERS: [phone]  FAX: [phone]
IN TERN ATI ON AL: [phone]  FAX: [phone]
CU STOMER SER VI CE (USA): 800 -882-0116  F AX: [phone]
WW W.MOEN .COM

Copyright Creative Specialties International Literature #BA1510

1. Position the mounting template on the wall in the desired location.

2. Using a level, align the template and tape it to the wall.

3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product.

4. Remove the template from the wall.

5. Fold ends of the plastic toggle together and insert into each hole in the wall.

6. Lightly tap anchors until flush with the w all.

7. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor. Remove pin and repeat on all anchors.

8. Remove mounting posts from the product assemblies by loosening each
setscrew .

9. Place the mounting plate on the w all over the installed w all anchors w ith “UP”
facing you.

10. Insert screws through the mounting plate into the anchors. Tighten the
screws.

11. Assemble the towel bar and posts.

12. While assembled, position each end post w ith setscrews facing down and
place over both mounting posts. Tighten the setscrew at the bottom of each
post.