Robe Hook post is die cast from
highest quality zinc alloy (Zamac).
Casting is plated in chrome, brushed
nickel or oil rubbed bronze.
DN3603BN – Robe Hook
Brushed Nickel
DN3603CH – Robe Hook
Chrome Finish
DN3603ORB – Robe Hook
Oil Rubbed Bronze
Cleaning Instructions:
Stock Number:_____________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
DN3603
Bradshaw™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
25300 AL MOEN DRIVE N ORTH OLMSTED, OH 44070
CORPOR ATE HEADQUARTERS: (800) 321-8809 FAX: (800) 848 -6636
INTER N ATIONAL: (440) 962 -2000 FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 FAX: (888) 379-2720
WWW. MOEN . COM
Copyright Creative Specialties International Literature #BA1514
1. Remove mounting posts from the product assemblies by loosening
each setscrew.
2. Position the mounting plate on the wall at desired location with “UP”
facing you. Mark hole locations.
3. Drill 2 holes as marked using 5/16” drill bit.
4. Fold ends of the plastic toggle anchor together and insert into each
hole in the wall.
5. Lightly tap anchors until flush with the wall.
6. One at a time, insert plastic pin into each anchor and lightly tap to
activate anchor. Remove pin and repeat on other anchor.
7. Place the mounting plate on the wall over the installed wall anchors
with “UP” facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with the setscrew
facing down. Tighten setscrew.
Loading...