Robe Hook
is constructed of zinc with
DN6303BC
–
Robe Hook
Cleaning Instructions:
FAX: (440) 962
-
2726 CUSTOMER SERVICE (USA): 800
-
882-0116
1.
Mounting hardware is included in the package.
tic wall anchor into each drilled hole by lightly tapping it
Attach each mounting bracket to the wall, by using the mounting bracket screws.
ounting bracket with the set screw facing
brackets.
Stock Number:
______________________Robe Hook
Materials:
Installation Instructions:
Dimensions:
Kelsey Technical Specification
2.54 IN
Robe Hook
Stock Numbers:
q
Brushed Chrome Finish
DN6303
2.55 IN DEEP
FROM FRONT
OF ROBE HOOK
TO WALL
3.125 IN
a ceramic insert.
2. Position the assembled unit on the wall where desired.
3. Lightly mark the outline of each base.
4. Remove the mounting brackets from back of the fixture by loosening the set
screws with the hex wrench provided.
5. Center a mounting bracket within each base outline.
6. Mark the hole locations of each mounting bracket.
7. Drill a ¼ inch hole at each location.
8. Insert the supplied plas
in flush. Note: Mounting into wood studs is recommended whenever possible.
9.
10. Place the assembled product over the m
down.
11. Tighten the set screw with supplied hex wrench to secure the assembly to the
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
By CSI Bath Furnishings
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070 (800) 321-8809 •
FAX: (800) 848-6636 • INTERNATIONAL: (440) 962-2000 •
Copyright CSI Bath Furnishing Division of Moen 02/22/01
Literature #BA1094
Loading...