Moen CSI1233 Specifications

Robe Hook is constructed of zinc.

 DN8503BN – Robe Hook

Brushed Nickel Finish

25300 AL MOEN DR I VE  NORTH OLMSTED, OH 44070
CORPORATE HEADQU ARTER S: [phone]  FAX: [phone]
INTERNATIONAL: [phone]  FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116  FAX: [phone]
WWW .MOEN .C OM

Copyright Creative Specialties International Literature #BA1308

Cleaning Instructions:

1. Remove mounting post from product assembly by loosening the setscrew.

2. Position the mounting post on the wall at desired location w ith notch facing
downw ard, and mark both horizontal hole locations.

3. Drill 2 holes as marked using 5/16” drill bit.

4. Fold ends of the plastic toggle anchor together (see Figure 1) and insert into
each hole in the wall.

5. Lightly tap anchors until flush w ith the w all.

6. One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor (see Figure 2). Remove pin and repeat on other anchor.

7. Place mounting post over anchors with notch facing downw ard, and insert
screws through post into anchors.

8. Tighten screws.

9. Place assembly over the mounting post with setscrew facing down and tighten
setscrew .

Stock Number:______________________Robe Hook
By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Robe Hook

DN8503

Cabrina® Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.