Moen CSI1221 Specifications

Paper Holder is constructed of zinc.

 DN8308BN – Paper Holder

Brushed Nickel Finish

 DN8308CH – Paper Holder

Chrome Finish

Cleaning Instructions:

1. Position the mounting template on the w all in the desired location.

2. Using a level, align the template and tape it to the wall.

3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product. (We recommend using the horizontal holes for drywall installation).

4. Remove the template from the wall.

5. Fold ends of the plastic toggle together (see Figure 1) and insert into each hole in
the w all.

6. Lightly tap anchors until flush with the w all.

7. One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor (see Figure 2). Remove pin and repeat on all anchors.

8. Remove mounting posts from the product assemblies by loosening each
setscrew .

9. One at a time, place each mounting post over anchors (notch facing downward)
and insert screw s through post into anchors.

10. Tighten screw s.

11. Place each assembly over the mounting posts with setscrew s facing down.
Pivoting post w ith bar should be on the left side. Tighten both setscrews.

Stock Number:______________________Paper Holder
By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Paper Holder

DN8308

Retreat® Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

25300 AL MOEN DRI VE  N OR TH OLMSTED, OH 44070
CORPOR ATE H EAD QU ARTER S: [phone]  FAX: [phone]
IN TERNATION AL: [phone]  FAX: [phone]
CU STOMER SER VICE (USA): 800-882-0116  FAX: [phone]
WW W.MOEN .COM

Copyright Creative Specialties International Literature #BA1325