Moen CSI1220 Specifications

Robe Hook is constructed of zinc.

 DN8303BN – Robe Hook

Brushed Nickel Finish

 DN8303CH – Robe Hook

Chrome Finish

Cleaning Instructions:

1. Remove mounting post from product assembly by loosening the setscrew.

2. Position the mounting post on the w all at desired location with notch facing
downward, and mark both horizontal hole locations.

3. Drill 2 holes as marked using 5/16” drill bit.

4. Fold ends of the plastic toggle anchor together (see Figure 1) and insert into
each hole in the wall.

5. Lightly tap anchors until flush with the w all.

6. One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor (see Figure 2). Remove pin and repeat on other anchor.

7. Place mounting post over anchors w ith notch facing downw ard, and insert
screws through post into anchors.

8. Tighten screws.

9. Place assembly over the mounting post with setscrew facing down and tighten
setscrew.

Stock Number:______________________Robe Hook
By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Robe Hook

DN8303

Retreat® Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

25300 AL MOEN DRIVE  NOR TH OLMSTED, OH 44070
CORPORATE H EADQUAR TER S: [phone]  FAX: [phone]
INTERNATI ONAL: [phone]  FAX: [phone]
CUSTOMER SER VICE (USA): 800-882-0116  FAX: [phone]
WWW.MOEN.COM

Copyright Creative Specialties International Literature #BA1324