Moen CSI1209 Specifications

Robe Hook is constructed of zinc.

 DN7703BN – Robe Hook

Brushed Nickel Finish

 DN7703CH – Robe Hook

Chrome Finish

Cleaning Instructions:

1. Remove mounting post from product assembly by loosening the setscrew .

2. Position the mounting post on the wall at desired location w ith notch facing
downward, and mark both horizontal hole locations.

3. Drill 2 holes as marked using 5/16” drill bit.

4. Fold ends of the plastic toggle anchor together (see Figure 1) and insert into
each hole in the w all.

5. Lightly tap anchors until flush w ith the w all.

6. One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor (see Figure 2). Remove pin and repeat on other anchor.

7. Place mounting post over anchors with notch facing downw ard, and insert
screw s through post into anchors.

8. Tighten screw s.

9. Place assembly over the mounting post with setscrew facing down and tighten
setscrew .

Stock Number:______________________Robe Hook
By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Robe Hook

DN7703

Lounge™ Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

25300 AL MOEN D RIVE  NORTH OLMSTED, OH 44070
COR POR ATE HEADQU AR TERS: (800) 321 -8809  FAX: [phone]
IN TERN ATIONAL: [phone]  FAX: [phone]
CU STOMER SER VICE (U SA): 800-882-0116  FAX: [phone]
WW W.MOEN .COM

Copyright Creative Specialties International Literature #BA1312