Moen CSI1203 Specifications

Oval Tilting Mirror posts are

constructed of zinc and mirror is
constructed of 5MM thick glass.

 DN6892BN – Oval Tilting Mirror

Brushed Nickel Finish

Cleaning Instructions:

1. Position the mounting template on the w all in the desired location. Using a
level, align the template and tape it to the w all.

2. Using a ¼” diameter drill bit, drill 4 holes as indicated on the template.

3. Remove template from the w all.

4. Remove the screws and w ashers from each of the 4 w all anchors in the
hardware kit. Set the screws and w ashers aside for later use.

5. Insert the hollow w all anchors into the 4 holes in the w all by lightly tapping w ith
a hammer until flush.

6. Remove mounting posts from end post assembly by loosening each setscrew.

7. One at a time, place each mounting post over the w all anchors w ith notch
facing down. Insert the screws and washers through the slots in the mounting
posts and into the wall anchors.

8. To activate the w all anchors, turn screws until you feel increased resistance.

9. Loosen the 2 small screws on each of the end posts.

10. With the back of the mirror facing you, slide the end posts into position on the
mirror (See figure 1). Align the screws with the holes in the back plates.
Tighten all 4 screw s.

11. Place mirror assembly over the mounting posts on the w all (setscrews facing
down). Tighten setscrews.

Stock Number:___________________Oval Tilting M irror
By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Oval Tilting Mirror

DN6892

Sage® Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

25300 AL MOEN DRIVE  NORTH OLMSTED, OH 44070
COR PORATE H EADQUAR TER S: [phone]  F AX: [phone]
IN TERNATI ONAL: (440) 962 -2000  FAX: [phone]
CU STOMER SER VIC E (U SA): 800 -882-0116  FAX: [phone]
WW W.MOEN. COM

Copyright Creative Specialties International 2005 Literature #BA1270