Moen CSI1173 Glenshire Oval Tilting Mirror Specification Sheet

Oval Tilting Mirror

posts are

DN

269

2BN–Oval Tilting Mirror

Cleaning Instructions:

Stock Number:

___________________Oval Tilting Mirror

Materials:

Installation Instructions:

Dimensions:

Oval Tilting Mirror

DN

26

92

Glenshire™ Technical Specification

Stock Numbers:

q

Brushed Nickel Finish

q DN2692CH – Oval Tilting Mirror

Chrome Finish

constructed of zinc and mirror is
constructed of 5MM thick glass.

1. Position the mounting template on the wall in the desired location.

2. Using a level, align the template and tape it to thewall.

3. Drill two 5/16” holes at each mounting post location.

4. Remove the template from the wall.

5. Fold ends of the plastic toggle together and insert into each hole in the wall.

6. Lightly tap anchors until flush with the wall.

7. One at a time, insert plastic pin into each of the anchors and lightly tap to

activate anchor. Remove pin and repeat on all anchors.

8. Remove mounting plates from the product assemblies by loosening each

setscrew.

9. One at a time, place each mounting plate over anchors (with “UP” facing

you) and insert screws through plate into anchors.

10. Tighten screws.

11. Loosen the 2 small screws on each of the end posts.

12. With the back of the mirror facing you, slide both end posts into position on

the mirror. Align the screws with the holes in the back plates. Tighten all 4
screws.

13. Place entire mirror assembly over the mounting plates on the wall

(setscrews facing down). Tighten setscrews.

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

By Creative Specialties

25300 AL MOEN DRIVE •NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: [phone] • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM

Copyright Creative Specialties International 2006 Literature #BA1350