Moen CSI1165 Specifications

1. Position the mounting template on the wall in the desired location.

2. Using a level, align the template and tape it to the wall.

3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product. (We recommend using the horizontal holes for drywall installation).

4. Remove the template from the wall.

5. Fold ends of the plastic toggle together and insert into each hole in the wall.

6. Lightly tap anchors until flush w ith the wall.

7. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor. Remove pin and repeat on all anchors.

8. Remove mounting posts from the product assemblies by loosening each
setscrew.

9. One at a time, place each mounting post over anchors (notch facing
downward) and insert screws through post into anchors.

10. Tighten screws.

11. Assemble the towel bar and posts.

12. While assembled, position each end post w ith setscrews facing down and
place over both mounting posts. Tighten the setscrew at the bottom of each
post.

25300 AL MOEN D RIVE  NORTH OLMSTED , OH 44070
COR POR ATE HEADQUAR TER S: (800) 321 -8809  FAX: [phone]
IN TER NATI ONAL: [phone]  FAX: [phone]
CU STOMER SER VI CE (U SA): 800 -882-0116  F AX: [phone]
WW W. MOEN. COM

Copyright Creative Specialties International Literature #BA1349

Towel bar posts are constructed of
zinc. Bar is constructed of brass.

 DN0822ORB – 24” Double Towel

Bar

Oil Rubbed Bronze Finish

Cleaning Instructions:

Stock Number:__________________ Double Towel Bar

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

24” Double Towel Bar

DN0822

Gilcrest® Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.