Page 1
Directions below are for installation into drywall. If installing product into a stud, use the
wood screws only.
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product.
4. Remove the template from the wall.
5. Fold ends of the plastic toggle together and insert into each hole in the wall.
6. Lightly tap anchors until flush with the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each
setscrew.
9. One at a time, place each mounting post over anchors (with UP facing you) and
insert screws through post into anchors.
10. Tighten screws.
11. Place each assembly over the mounting posts with setscrews facing down.
Tighten both setscrews.
12. Compress the paper holder bar and place into posts.
25300 AL MOEN D RI VE NOR TH OLMSTED, OH 44070
COR PORATE H EADQU ARTER S: (800) 321-8809 F AX: (800) 848-6636
IN TER NATION AL: (440) 962-2000 F AX: (440) 962-2726
CU STOMER SER VIC E (U SA): 800-882-0116 F AX: (888) 379-2720
WWW.MOEN .C OM
Copyright Creative Specialties International Literature #BA1246
Paper Holder posts are constructed
of zinc. The roller is constructed of
aluminum.
DN2608BN – Paper Holder
Brushed Nickel Finish
DN2608CH – Paper Holder
Chrome Finish
Cleaning Instructions:
Stock Number:______________________Paper Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
DN2608
Glenshire® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Loading...