Directions below are for installation into drywall. If installing product into a stud, use
the wood screws only.
1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product. (We recommend using the horizontal holes for drywall installation).
4. Remove the template from the wall.
5. Fold ends of the plastic toggle together and insert into each hole in the wall.
6. Lightly tap anchors until flush w ith the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each setscrew.
9. One at a time, place each mounting post over anchors (notch facing downward)
and insert screws through post into anchors.
10. Tighten screws.
11. Place each assembly over the mounting posts with setscrews facing down.
Pivoting post w ith bar should be on the left side. Tighten both setscrews.
25300 AL MOEN DR IVE N ORTH OLMSTED , OH 44070
COR PORATE HEAD QUAR TER S: (800) 321-8809 FAX: (800) 848 -6636
IN TERNATI ONAL: (440) 962 -2000 FAX: (440) 962-2726
CU STOMER SER VIC E (USA): 800 -882-0116 FAX: (888) 379-2720
WW W.MOEN. COM
Copyright Creative Specialties International Literature #BA1240
Paper Holder is constructed of zinc.
DN0808ORB – Pivoting Paper
Holder
Oil Rubbed Bronze Finish
Cleaning Instructions:
Stock Number:______________________Paper H older
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
DN0808
Gilcrest® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Loading...