Moen CSI1007 Specifications

25300 AL MOEN D RI VE  NOR TH OLMSTED , OH 44070
COR PORATE H EADQU ARTERS: [phone]  F AX: [phone]
IN TER NATION AL: [phone]  FAX: [phone]
CU STOMER SERVI CE (USA): 800-882-0116  FAX: [phone]
WW W. MOEN .C OM

Copyright Creative Specialties International

Paper Holder is constructed of zinc.

 YB2208BN – Paper Holder

Brushed Nickel Finish

 YB2208CH – Paper Holder

Chrome Finish

 YB2208OR B – Paper Holder

Oil Rubbed Bronze Finish

Cleaning Instructions:

Directions below are for installation into drywall. If installing product
into a stud, use the wood screws only.

1. The center to center measurement for this product is 6 ¼”.

2. Mark this distance on the wall where you want to install the product.

3. Use a level to ensure that the pilot holes will be perfectly level.

4. Using ¼” drill bit, drill one pilot hole for each post.

5. Position mounting posts to wall by inserting wall anchors into pilot
holes and pressing firmly. (Make sure that locking tab on mounting
post is facing down.)

6. Tighten wall anchor screw while holding mounting post firmly in
place. Tighten anchor until resistance increases. DO NOT over
tighten.

7. Using tip of screw bit press wall spikes (metal pieces on outer edge
of mounting post) into drywall.

8. Towel bar must be attached to mounting posts as a unit – insert
towel bar into each post.

9. Attach posts by pressing firmly to mounting posts until it clicks. (The
square opening at the base of the post must be facing down to
match-up with locking tab).

Stock Number:______________________Paper Holder
By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Paper Holder

YB2208

Brantford™ Technical Specification

To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Literature #BA1395