RGB Installation Step 1
Locate screws holding in the glass and remove
RGB Installation Step 2
Carefully remove glass panel by pulling on the tabs located on the left and
right side of the firebox.
RGB Installation Step 3
Locate RGB Light ember kit inside of unit box which consist of clear strip,
glass chunks, glacier crystals, RGB light strand, RF Receiver and RGB remote.
RGB Installation Step 4
Locate red and yellow wires coming off the mother board
and off the driver box. Plug in wires to each other.
RGB Installation Step 5
Locate RGB light strip and remove paper
covering sticky strip. Place RGB light strip
along bottom rail of Z metal attached to unit.
Locate plug on the RGB light strip and the
driver box. Plug in wires to each other.
RGB Installation Step 6
Locate glass glaciers and glass
chunks. Place glass glaciers along
the clear strip covering the entire
bottom tray. Evenly place glass
chunks on top of glass glaciers in the
direction desired.
Replace glass in front of unit where it was
first removed.
1
Loading...