Modern Flames AMBIANCE LINEAR 40, AMBIANCE LINEAR 60, AMBIANCE LINEAR 100 Operations Manual
Read these instructions completely before beginning installation. Failure to follow them could cause a heater malfunction
resulting in serious injury and/or property damage.
WARNING: All electric heaters have hot and arcing or sparking
parts inside. Do not use it in areas where gasoline, paint or
flammable liquids are or are stored.
This fireplace meets the construction and safety standards of
H.U.D. for application in manufactured homes when installed
according to these instructions.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
AMBIANCE LINEAR 40
AMBIANCE LINEAR 60
AMBIANCE LINEAR 100
SAFETY INFORMATION AND OPERATIONS MANUAL
2
Table of Contents
Safety................................................2
Listing Approvals...............................3
Product Dimensions..........................4
Box Contents………..........................5
Unpacking and Testing…..................5
Locating Fireplace.............................6
When using electrical heaters, basic precautions should always be followed to
reduce the risk of fire, electric shock and
injury to persons, including the following:
1. Read all instructions before using this
heater.
2. Keep combustible materials, such as
furniture, pillows, bedding, papers,
clothes and curtains away from front
of heater. 1.5 yards minimum clearance required.
3. This heater is hot when in use. To
avoid burns, do not let bare skin touch
hot surfaces. The grill directly in front
of heater outlet becomes hot during
heater operation.
4. Extreme caution is necessary when
any heater is used and whenever
heater is left operating and unattended.
5. Always unplug heater when not in
use.
6. Do not operate any heater with a damaged cord or plug or if heater malfunctions or has been dropped or damaged in any way. Return heater to
authorized service facility for examination, electrical or mechanical adjustment or repair.
7. Do not use outdoors.
8. This heater is not intended for use in
bathrooms, laundry areas and similar
WARNING: Improper installation,
adjustment, alteration, service or
maintenance can cause injury or
property damage. Refer to this
manual. For assistance or additional information, consult a
qualified installer.
CAUTION: Do not expose the
heater to the elements (such as
rain, etc).
Do not place clothing or other
flammable material on or near
firebox. Never place any objects
on the fireplace.
Carefully supervise young children when they are in the room
with fireplace.
Fireplace becomes very hot
when running. Keep children and
adults away from hot surfaces to
avoid burns or clothing ignition.
Fireplace will remain hot for a
time after shutdown. Allow surfaces to cool before touching.
Do not install fireplace directly
on carpet or similar surface
which may restrict air circulation beneath unit.
Installation........................................6
Operation.........................................9
Service Parts……………………….10
Frequently Asked Questions……..12
Troubleshooting……………………13
Safety
3
indoor locations. Never locate heater
where it may fall into a bathtub or
other water container.
9. Do not run cord under carpeting. Do
not cover cord with throw rugs, runners or the like. Arrange cord away
from traffic area and where it will not
be tripped over.
10. To disconnect heater, turn controls to
the OFF before removing plug from
outlet.
11. Do not insert or allow foreign objects
to enter any ventilation or exhaust
opening as this may cause an electric
shock or fire or damage the heater.
12. To prevent possible fire, do not block
air inlets or outlets in any manner. Do
not use on soft surfaces, like a bed,
where openings may become
blocked.
13. Always use properly grounded fused
and polarized outlets.
14. A heater has hot and arcing or spark-
ing parts inside. Do not use it in areas
where gasoline, paint or flammable
liquids or vapors are used or stored.
15. Use this heater only as described in
this manual. Any other use not recommended by the manufacturer may
cause fire, electric shock or injury to
persons.
16. Avoid the use of an extension cord
because the extension cord may
overheat and cause a risk of fire.
However, if you have to use an extension cord, the cord should be No.
14 AWG minimum size and rated not
less than 1875 WATTS.
17. Always use ground fault protection
where required by electrical codes.
18. Always disconnect power before performing any cleaning, maintenance or
relocation of heater.
19. To prevent a possible fire, do not
burn wood or other materials in this
heater.
20. To prevent electric shock or fire, always use a certified electrician
should new circuits or outlets be required.
21. When transporting or storing heater,
keep in a dry place.
22. Control panel door gets hot during
heater operation. Open door by
pressing on right corner. A spring
magnet will disengage. Pull door
down to open.
23. SAVE THESE INSTRUCTIONS
Safety
Listing Approvals
This heater has been tested in
accordance with the CSA Standards for fixed and locationdedicated electric room heaters
in the United States. This fireplace is UL or CSA safety certified.
AL-100 CLX AL-60CLX AL-40 CLX
Volts AC 120V/60Hz AC 120V/60Hz AC 120V/60Hz
Amps 15 Amp 15 Amp 15 Amp
Watts 1570 W 1530 W 1520 W
Heater
AC 120V/60Hz
1500W
AC 120V/60Hz
1500W
AC 120V/60Hz
1500W
No Heater
Lamps
LED DC12V 5W*7
LED DC3V 3W*8
LED DC12V 5W*3
LED DC3V 3W*4 LED DC12V 5W*3
Rotor motor
AC 120V/60Hz 4W
CCW 15/18 r/min
AC 120V/60Hz 4W
CCW 15/18 r/min
AC 120V/60Hz 4W
CCW 15/18 r/min
Shipping Size 2600*230*800mm 1590*230*800mm 1080*230*800mm
Shipping Weight
4
Product Dimensions
AL CLX 40
40” W x 25.5” H x 3.48” D
AL CLX 60
60” W x 25.5” H x 3.48” D
AL CLX 100
100” W x 25.5” H x 3.48” D
5
Box Contents
Unpacking and Testing
Carefully remove unit from box. Prior to
permanently installing unit, test to make
sure unit operates properly. To do this,
plug unit's power supply cord into a conveniently located 120-volt grounded outlet.
CAUTION: The unit's power
supply cord must be connected
to a properly grounded and protected 120-volt outlet. Always
use ground fault protection
where required by the electrical
code.
WARNING: Do not operate the
unit if it is damaged or has malfunctioned. If you suspect the
unit is damaged, return the unit
to an authorized service facility
for examination, electrical or
mechanical adjustment or repair.
1 Mounting
Bracket
1 Fire Unit
1 Glass Face
3 L-metal
Brackets
4 Wall Anchors
8 Small Washer
Head Screws
4 Large Washer
Head Screws
1 Remote
Loading...