Modern Fan Co Torsion Installation Instructions Manual

MODERN FAN COMPANY
Customer Service
M-F 8am - 4pm (PST)

(ph) 888.588.3267
www.modernfan.com

(1) Remove and identify contents of carton.

Torsion Fan- Installation instructions

Should you have any questions or difficulty installing your new fan,
please contact Modern Fan Co. customer service immediately.

Note: Power supply must be turned off prior to any contact with electrical
wires. It is recommended that a licensed electrician be hired to install your

ceiling fan.

Torsion

half
ball

balancing

kit

blades

hardware

package

optional

control

fan body

hanging
bracket

down

rods

canopy

(2) Using machine screws from hardware package
or existing screws in junction box, securely attach
hanging bracket to ceiling junction box.

(3) Remove stopper pin and half ball from small
down rod by loosening set screw on half ball. Set
parts aside for reinstallation in step (7).

stopper pin

set screw

(4) Place fan body face down on packaging
(careful not to damage light socket if installed).
Remove the stopper screw and loosen the set
screw on the fan collar. Set the stopper screw
aside for step (5).

set screw

(6) Slide fan canopy over down rod and carefully
rest on top of fan body.

canopy

(7) Reinstall half ball from step (3) on end of down
rod. Be sure that stopper pin is inserted through
down rod and seated in half ball. Tighten set
screw against down rod.

stopper pin

set screw

(5) Run fan wires through selected down rod.
Reinstall stopper screw from step (4) and firmly
tighten set screw on fan collar against down rod.

Note: If ceiling height allows, using a longer down
rod will increase airflow and efficiency.

stopper screw

(9) Lift fan to ceiling and set half ball in the
hanging bracket so that the ridge on the edge of
the hanging bracket is seated in the slotted
channel in the half ball.

channel and ridge

(10) With fan safely suspended by bracket, make wire connections with wire
nuts included in hardware package as described in the Control Installation
Instructions. If using optional #003, #004 or #005 controls, the receiving
unit should be placed inside the arms of the hanging bracket and
connected at this time.

(8) Using blade screws and washers from
hardware package, secure each of three blades to
rotor arms.

(11) Loosen set screws on the sides of the
hanging bracket. Lift canopy to ceiling. Align slots
on side of canopy with set screws on hanging
bracket, rotate canopy and tighten set screws to
hold canopy in place.

set screw